Forum Replies Created
-
Posts
-
Re: Beko WMA765S
Just fitted a Module i rescued from a scrap WMA510 for the same fault and it cured it, i guessed it would be the module as it filled and i could not hear any relay clicking to power the motor, but the again i just think i was lucky JJ
Re: HPT new belt fitting tool
I remove the 2 side panels, then remove 2 screws holding the rear of the water bottle contaner unplug suppressor remove 2 screws holding bracket to back panel then remove pin to rear bearing ease the back panel away from the drum slip the belt in and around the drum, reasemblethe above apart from side panels then remove duct and cooling fan slip belt over motor slacken the pulley removing the nearest screw i then use the the pulley along with a hook tool i have had from years ago to fit dishwasher springs, to stretch the belt, all in usualy takes about 20 mins. JJ
Re: ADP8332 Salt contaner nut
Thats where the problem is the customer had somebody in who changed the flow meter and salt container minus the nut, and has been trying to get him back for about 3 months now i have been lumbererd with it, if it comes to the crunch i’ll order the 2 and he will have to pay for both, jj
Re: Aqualtis facia board removal
The facia board is a dawdle, itls take about 5 mins, what is the fault i’ve had a few that have been dead and turned out to be the facia board, if you have another wf board just plug it into the aqualtis wiring see if it lights up. JJ
Re: Hotpoint Drum/Spider Advise
If the torx screws are not to rusty i find if you give the heads a good couple of wacks with a drift, most of the time they will unscrew fairly easily if you need to drill out as Jim says a Titanium drill does the job,JJ
Re: Hotpoint WDD960P bearings gone
Had a few washing macine bearings failing but not the washer dryers, watch when you fit them as i have had a few call backs for noise, and found the rear bearing was loose i usauly fit the bearings and secure them with bearing fit now so far not had a call back on these ones. JJ
Re: HOTPOINT – FRIDGE FREEZER FFA74
These are prone to internal leaks usualy from the aqnticondesation loop around the freezer, the divertor valves dont give much problems,jj
