[johnnyj]

Re: Hotpoint dishwasher DWF70SB

Jus wondering if it is in the lower position, as when larger items are placed in the spray arm catches them, JJ

[johnnyj]

Re: BAUMATIC BF62W

Thanks Chris

[johnnyj]

Re: Hotpoint FDL 570

From underneath not a bad job actualy it attached to the motor, just watch when you tighten hose clips as one of the hoses is easy to nick and cause a leak.jj

[johnnyj]

Re: ADP9411/2

iTS OKAY FOUND IT ON MASTERPART jJ

[johnnyj]

Re: hotpoint wma58 stops

Have you checked the cold valve sounds like it is open circuit.

[johnnyj]

Re: Indesit FI31K.B.IX.GB – Oven T.O.C.

Its the toc situated on the back of the oven that is causing the problem the temp was increased to stop them from tripping i cannot remember the part n/o offhand. But i’m sure it is the one Martin posted earlier. JJ

[johnnyj]

Re: Hotpoint FDF780 D/W dead?

Yes Jim l have my old clear hard ware key that i use as a quick test to see what the last fault was and to check if the board is powering upJJ

[johnnyj]

Re: Hotpoint FDF780 D/W dead?

Prob’ly the main board fitted a couple aslo the wires going down through the door are prone to breaking, do you have a test plug you can plug into the board to see if it lights up sometimes there is power to the board but it doesnt power up JJ

[johnnyj]

Re: Hotpoint FFA71G – Fridge is freezing…

These are prone to system faults, seen loads of them with the fridges freezing and freezer defrosting. They leak from the anticondensation loop around the freezer door due to corrosion.

[johnnyj]

Re: Hotpoint ET 6004 hob

Its an induction hob and the parts are rather pricey, if iwas you i’d body swerve it and pass it back to Indesit if it is under 5 years old jj

[johnnyj]

Re: HP wf440 Unknown bearing set.

If it is 1400 rpm or under it is normaly 30mm bearings, jj

[johnnyj]

Re: How to decide what to store and what to scrap?

Just a thought isnt the parts that EMW and QER supply in effect second hand parts?. Who’s liability insurance is liable there.

[johnnyj]

Re: wd72 not fill

As Chris says check the heater if it is down to earth it wont fill.

[johnnyj]

Re: hotpoint wf540 wiring diagram

Best bet is to fit a new motor/pump harness part n/o C00203626, JJ

[johnnyj]

Re: Hotpoint TDL15 NO Motor

Could be a timer or a duff motor, best bet is to check the motor windings, then carry out a continuity check from the plug top through the timer to the motor to confirm if it is faulty.

[Author]

Posts