Forum Replies Created
-
Posts
-
Re: Hotpoint WMA50
Sounds like the pcb i’m afraid, mind and check the wiring around the front balance weight, tie it up out off the way.
Re: Mobile printers
I thought about the pocket jet, but plumped for the brother it is a thermal printer also, dimensions 210mm x 130mm x 18.5, you can print A6 or A7 and you gat pads of 50 sheets for about £3.00, rather than a roll of fax paper to feed in to the pentax.
Re: Mobile printers
Plumped for the Brother MW 260, i only want it to print invoices, and some labels. I will use my main printer for anything serious.
Re: Aberdeen
I know was tearing back to meet my brother in law, when the missus phoned to tell me it was off, ah well i’ll just pop down t the pub for a few ambers.
Re: Hotpoint CTD00G Door Pin
There are 2 springs on the sw kit if you stretch the small one or find another slightlty stronger usualy does the trick, aslo put a screw between the 2 locating tabs as the sw’s were getting pushed inside and not operating. jj
Re: Hotpoint dryer CTD00.
Sounds like the timer if everything else checks out, not common but they do fail. JJ
Re: Hotpoint VTD20 tumble drier.
Chris i have the correct belt tool but never use it nowadays as it doesnt fit in my toolbox and a screwdriver never lets me down. jj
Re: Hotpoint VTD20 tumble drier.
Remove top cover, then remove right hand side panel remove console panel, push front panel outwards slip belt ond drum secure front panel and console, get the biggest screwdriver you can find and strecth belt via motor pulley with the screwdriver, turn drum while guiding belt onto pulley refit side panel and top cover, 10 mins should do it. JJ
Re: ctd00
As the white spot is the the one shot, the 120 will be the cycling stat, and the 140 will will be the one shot.JJ
Re: wf630
It is only the 7kg machines that have a differant drum front half and rear half, i replace the 30 mm back half all the time with a 35 mm, the 30 mm bearings were fitted to all the 1400 spin and under machines, the 1600 spin all were fitted with 35 mm ones.
Re: Diplomat ACA9202
Hi Andy i only have accounts for Connect and qualtex i never got round to registering for Masterpart, does anybody know if any of these two stock them cheers, JohnnyJ
Re: CANDY CM1 166/1-80
Thanks Chris i asume its the bord as i get a supply to the machine but nobody is home no lights nothing, customer advised it stopped mid programe, a couple of times when they sw’d on the lights flickered. jj
Re: Hotpoint/Creda TD bearing pads
They used to 5 on the very 1st machines, but we were advised to remove or leave out the top right hand pad, as the drums were getting jammed on some of them, JJ
