Forum Replies Created
-
AuthorPosts
-
johnsdad
ParticipantRe: Smeg DWI612c
Its an NTC temp sensor
johnsdad
ParticipantRe: Admiral GC22244GEKW keeps defrosting
program it to 05, it usually keeps the damper open for slightly longer
johnsdad
ParticipantRe: Beko CDA563
compressor every time
johnsdad
ParticipantRe: beko wm5120 – 1st wash and just stuck in program
If its first wash i’d suspect plumbing issue?
johnsdad
ParticipantRe: samsung defrost heater/evaporator
Heater is DA81-01691A
johnsdad
ParticipantRe: Samsung cool ‘n’ cool SR-L3916BSS
probably faulty defrost heater, appliance never comes out of defrost because it cannot sense a temperature rise at the evaporator
johnsdad
ParticipantRe: Samsung FF dead.
icemaker sensor fault
johnsdad
ParticipantRe: Liebherr fridge F2 fault.
Part no. 9590088 is more suitable, comes with splicing connector, quite a common fault on Liebherr
johnsdad
ParticipantRe: Liebherr fridge F2 fault.
F2 = evaporator sensor fault
johnsdad
ParticipantRe: Admiral GC2224GEKB not defrosting
67004757
johnsdad
ParticipantRe: Samsung B1445AS
could be B1445ASG1
johnsdad
ParticipantRe: Neff Side by Side Fridge Freezer
Thats right, just check the plastic housing has not distorted from the heat of the solenoid. Also sometimes damages cube/crush solenoid next to auger motor
johnsdad
ParticipantRe: smeg dishwasher DWD1SS e3 error
e3 = temperature rise not detected
johnsdad
ParticipantRe: Beko AP930 No water supply to ice cube tray
The reason the tube freezes is because the heater switch under the dispenser is in the off position
johnsdad
ParticipantRe: maytag GZ2626GEKB
12868513
-
AuthorPosts
