Forum Replies Created
-
AuthorPosts
-
jontymox
ParticipantRe: Bosch SGS66A02GB/21 Dishwasher Tripping Out
Good morning,
To conclusively test for low insulation I attach the positive lead of my Megger to the positive terminal of the heater, and the negative lead to the element itself.
As the heater in question is a remote unit, I did not carry out an insulation test as above, as I didn’t wish to break the unit in removing it from it’s plastic housing.
I was pretty sure the heater was the cause of the fault, as no tripping occurred when disconnected from the circuit… one clearly was mistaken, and can learn from this mistake!
In the meantime, could you please cease highlighting sentences, and commenting on them in such a sarcastic and humiliating manner?
Thank you,
jonty
jontymox
ParticipantRe: Bosch SGS66A02GB/21 Dishwasher Tripping Out
Thanks for your input Martin,
No, I didn’t megger the heater as the only way I know to correctly do so is to place one lead on the element itself.
I suspected the heater unit was faulty as the m/c didn’t trip when heater connection disconnected.
Best wishes,
jonty
jontymox
ParticipantRe: Stoves 059056600 Range Oven Cutting Out
Thanks for your input Seamy,
I obtained the replacement ‘stat, 082558001 but as you say a conversion kit is required.
However, Stoves and other suppliers assure me that no such kit is available!
Will investigate further,
jonty
jontymox
ParticipantRe: Stoves 059056600 Range Oven Cutting Out
Returned earlier this week and confirmed oven thermostat faulty.
I did inspect and check the terminal block as suggested.
Unfortunately thermostat: 081835801 is now obsolete, and no replacement available through Stoves.
I’ve been unable to obtain the genuine or replacement part through the other usual channels/anywhere!
One supplier is kindly trying their best to obtain replacement.
In the meantime I would be grateful if sarcastic, unpleasant comments were not placed on this fine resource.
Kind regards/best wishes,
jonty
jontymox
ParticipantRe: Stoves 059056600 Range Oven Cutting Out
Evening all,
I am certainly not asking for a “remote diagnosis!”
As a relative newcomer, certainly to range ovens, I am quite simply tring to obtain some advice and information in order to become more conversant with such problems.
Ideally, I should have spent more time trying to diagnose the fault on my initial visit.
However, as I couldn’t conclusively fault the main thermostat, I thought I would see if I could obtain some info’ as I understand a safety thermostat may also be at fault for this problem.
Will return, and carry out further tests and inspections, which hopefully will shed some light on the issue.
jontymox
ParticipantRe: Stoves 059056600 Range Oven Cutting Out
No,
Ideally I would like to rectify the problem first time, though realise this may not be possible.
Will let you know how it goes.
jonty
jontymox
ParticipantRe: Siemens SE25M275GB/36 Dishwasher Prob’s
Thanks Martin,
Will investigate further.
jonty
jontymox
ParticipantRe: Siemens SE25M275GB/36 Dishwasher Prob’s
Good morning,
Still struggling to get dishwasher to wash consistently.
The matrix does not fill fully as Martin enquired, and wonder if this is the underlying cause?
Where should I be checking as matrix is clear/unblocked, as is pipe from pressure chamber to pump.
Regards,
jonty
jontymox
ParticipantRe: Siemens SE25M275GB/36 Dishwasher Prob’s
Good morning,
Have now re-set electronics, and set up test at workshop.
Machine will now operate at a reduced efficiency, notable by much less than normal amount of water being admitted, thus wash pump barely
managing to spin spray arms.Heating up fine, and hasn’t tripped out.
Unable to locate an impellor jug, which I understand can cause this problem, and wonder if there is a different device on this m.c?
jonty
November 21, 2012 at 12:05 pm in reply to: NEFF Integrated Microwave Oven H5642NOGB/02 Not Heating #385079jontymox
ParticipantRe: NEFF Integrated Microwave Oven H5642NOGB/02 Not Heating
Thanks Dr.Drill,
Is is possible for me to partially strip the unit to check for anything obviously amiss?
Or is that not recommended?
Otherwise, NEFF engineer to advise.
Kind regards,
jonty
jontymox
ParticipantRe: Siemens SE25M275GB/36 Dishwasher Prob’s
Agreed,
Will carry out re-set, and go from there.
Thanks Martin,
jontymox
jontymox
ParticipantRe: Siemens SE25M275GB/36 Dishwasher Prob’s
No,
Could you provide the sequence to re-set electronics?
Jonty
September 15, 2012 at 7:25 am in reply to: Rangemaster 110 Clock/Timer Renewal – Eectric – 53440041 #381267jontymox
ParticipantRe: Rangemaster 110 Clock/Timer Renewal – Eectric – 5344
Thanks Gents,
Yes, it’s a solid plate type.
Will remove appliance to access screws, and gain access to timer.
Kind regards,
Jon
jontymox
ParticipantRe: NEFF Semi – Integrated Dishwasher S4456N3GB/35
Thanks Criscold,
Removed and renewed heater unit to cure problem.
Was unable to locate “how to” on site, but good job done.
Jon
jontymox
ParticipantRe: Bosch SHV5SM03GB/79 Int’ Dishwasher tripping
Thanks LMTGOWI,
Removed and renewed heater unit, to cure tripping fault… stripped unit, and element burnt in one area.
Jon
-
AuthorPosts
