Forum Replies Created
-
Posts
-
Re: John Lewis JLWD1408 washer/dryer tripping RCD switch
If it’s a zanussi try disconnecting the dryer heater causes lots of problems
Re: Hoover DXP48AIW3
I wouldn’t have thought so I check with hoover engineer tomorr and post back on here if they have
Re: hoover dyn9164dpg
Meggar the appliance something will be low also the water valve links into the pump on some hoover machines
Re: hoover DYN8144 DIX
Meggar the appliance as this is dissipation from the heater anything low insulation on hoover machines the modules do weird things.
Re: hotpoint wmd960 intermittent pumping
The new Acadia modules can’t be programmed off the machine the top pcb has to be connected the smart card reader and smart cards are expensive but I have never had a problem with them hotpoint trade parts will be the best for this they will beat any trade price
Re: hotpoint wmd960 intermittent pumping
Put a new module not a repaired one it’s definitely a pcb fault I’ve had this problem with repaired pub off them before
Re: Siemens Dryer cuts out 5 minutes
On Bosch and Siemens vented dryers the vent hose has to be 600mm before a bend and airflow is key on these the ntc is located behind the bottom left plastic cover so it’s easy to check,hope this helps kai
Re: hoover dyn9164
Part number you need is 09200657 this suspension fits most hoover machines after 2006 hope this helps
Re: Bosch washing machine burning smell inside drum
Sealed drum on this model so it will need new drum
Re: Beko Washing Machine
If it’s got a brushless motor chances are its a motor faulty which gives you the impression it could be a module kai.
Re: Hoover DYN9164DPG 3100500913183080 Error: E08
The part number for the programmed module is 49026463 which is out of stem with connect and special order with qualtex hope this help any queries on hoover / candy I’m your man ex bias engineer hope this helps you kai
Re: Bosch Exxcel dryer- Stops with ‘Empty Filter’ warning
Check the pump it does clog up with fluff and bosch like to have plenty of airflow so check the front fan aswell hope this helps kai
Re: Beko condenser dryer heating problem
Change the pcb make sure you order correct part as the pcb can look vertical identical and the toc this will sort the problem
