Forum Replies Created
-
Posts
-
Re: wet2820gb/13 fd8203
I would look at checking all the components on the dryer 1st I know on the zanussi w/d the dryer element gives all sorts of problems
Re: WF741 pumping out in 3s bursts
Yea put a new pcb nt a repaired 1 have had problems with faulty bard from emw
Re: HooverDXA 68 washing machine
Sounds like a faulty motor to me they are having a few issues with them
Re: Bosch SGS43C02GB/35 fills and drains but doesn’t wash
Hi there is a jug impeller which is normally located after the water value normally connected with a blue pipe I would look at that 1st
Re: Gas safe portfolio
I have been qualified for just over 2 years now and I can tell you I was a nightmare training it took over a year to do the number of jobs is irelivent you need experience on boilers fire and cookers. The hardest part is finding a gas safe engineer to train with I do wonder if it was worth doing sometimes
Re: Where to buy appliances?
Try gillmans if your in glouster area local euronics dealer good aftersales
Re: FDL570 – Not finishing
F08 is normally a pcb module fault heater relay need a engineer out as a new module will need programming
Re: Hoover VHC 381/1 -80
Three 7mm screws holding the lid on at the back then 2 screws holding the facia on then the door and the door seal needs to come off plus screws around where the door seal, may be 2 screw holding the front panel at the top as well and there are 2 screws holding the front panel on from the bottom one near where you pull out the condenser and one the opposite end 2 wire on the door lock doesn’t matter what way around you put them
Re: Flavel Milano 60 Glass Hob Lid Springs
if you can read the data plate there will be a number starting with 7 this is how you can find correct part
Re: Removing cooking top on a Zanussi ZCG551GXC
this is a gas appliance you must have a gas safe registered engineer to look at it.
Re: Hotpoint WD420 not starting
I would get rid of it normally either the door lock or the brushes cause this problem which you have checked,the only other thing for you to check is the motor wiring and the door lock wiring if these are fine you could well be looking at a pcb fault, also i can see the dryer worked now and again if there is a fault on the dryer that can cause the wash side not to work properley also. but if every light on the machine flashes this is a pcb fault.
Re: Indesit W/M IWD5123 not going into drain cycle
before booking an engineer or buying a new machine it is also worth checking the sump hose which is located at the bottom of the machine and connects to the pump maybe a blockage there
