[Latham63]

Yes, not that!

[Latham63]

Thanks Dave.
Customer decided to replace the machine!

[Latham63]

Ok,thanks guys.
Yes the PNC ends 01,my mistake!
Think I`ll try a new fan as coil fault sounds most likely.

[Latham63]

Hi Jem/Dave
PNC is 94406457610
240v to the fan

[Latham63]

Thanks Dave
However the door locks when prog started,followed by a brief noise for a split second (like a valve opening) ,then nothing..
I`m thinking pcb or just replace the machine?

[Latham63]

Tried a pcb + had a spare 2nd hand motor,same error code in both cases?
Stumped on this one..

[Latham63]

Motor checks out ok,as does heater. So not sure where to go with this one.
Perhaps try a pcb.

[Latham63]

Thanks Dave
I`ll check out & see!
Paul.

[Latham63]

Thanks Dave
The model number is g1152sc if that helps

[Latham63]

Ok thanks Dave
I`ll check out the NTC ,on the heater presumably?
Paul.

[Latham63]

The relays look burnt. Cleaned the contacts. Haven`t checked the relay is operating!
Thanks Dave.

[Latham63]

Thanks Dave. Makes sense if the flow is slower. The circulation pumps are cheap & nasty too!

[Latham63]

Ok, thanks, will do

[Latham63]

Any know if the top pcb controls the fridge temperature or is there a separate stat?

[Latham63]

Re: Electrolux ESL5201L0 Dishwasher no heat

Latham63 wrote:Heater element ok.
Getting 130V on neutral & 200 V on live supply to heater?
Is there a heater Pcb on these?

[Author]

Posts