[Latham63]

Re: Hoover Optima OPH614-80 Error code

Turned out 15 flashes = pcb not programmed. The pcb I received was supposed to be programmed(apparently not!) Ordered another,which was progammed.Machine ok now!

[Latham63]

Re: Hotpoint WT540 washing machine error code

Thanks,a reconditioned pcb did the trick!

[Latham63]

Re: Zanussi ZWD12270W Washer dryer. Cuts out

How do I get into diagnostics?

[Latham63]

Re: Zanussi TCE7124W Dryer cuts out

That makes sense & would explain the condensation.He hasn`t rang back,but will give him your advice,Cheers Martin.

[Latham63]

Re: Zanussi FX1465W Washing machine.Aborts from start.

Ok will return once more with pressure switch treatment.Fingers crossed! Thanks again.

[Latham63]

Re: Zanussi FX1465W Washing machine.Aborts from start.

Tried suggestions,still no go! Only there are now 3 beeps/flashes then pause,repeating…does this mean something?
Pcb looks ok? Door interlock replaced,no change.

[Latham63]

Re: Zanussi FX1465W Washing machine.Aborts from start.

Thanks Martin,will give it a whirl.

[Latham63]

Re: Zanussi FX1465W Washing machine.Aborts from start.

Is there a test procedure I can use?

[Latham63]

Re: Zanussi FX1465W Washing machine.Aborts from start.

mmmmm interlock locks when prog selected!

[Latham63]

Re: Neff S5443X1GB/17 Dishwasher No water in

Good point.Though I assumed the wash motor would not cut in until water had been introduced? But yes will check valve!

[Latham63]

Re: John Lewis JLWM1203 Washing machine No Spin/wash

Ok will check it out,thanks

[Latham63]

Re: Hotpoint FDW60P Dishwasher No Go

Thanks,still suspect more trouble than its worth.Will see.

[Latham63]

Re: Zanussi ZWF1431W Washing machine E30

Thanks for diagnostic info.Have since taken machine to my workshop,plugged in and it works perfectly!!
Now suspect the customers house electrical supply fault!

[Latham63]

Re: Zanussi ZWF1431W Washing machine E30

Not sure how to do diagnostics on this machine? Never heard of air trap?

[Latham63]

Re: Zanussi ZWF1431W Washing machine E30

Martin,tried a new heater(old one tested ok with mega),initially started to work,taking in water!Tested this twice,ok. Then when I thought all was well,started up again, prog aborted and E30 again! All I can think is module fault?

[Author]

Posts