Forum Replies Created
-
AuthorPosts
-
Latham63
ParticipantRe: Zanussi FJ1254W Washing machine- Error code
Problem turned out to be very low water pressure.The water softener fitted to house supply was blocked! Bypassed ok.
Latham63
ParticipantRe: Zanussi FJ1254W Washing machine- Error code
Yes
Latham63
ParticipantRe: LG WM-16220FD Washing machine Overfills
Turned out to be an intermittent sticking valve! Replaced,ok.
Latham63
ParticipantRe: Miele G2530SCI Dishwasher F68
By the time I arrived mains/macchine had dried out.End of problem!
Latham63
ParticipantRe: Miele W2203 Washing machine.Flashing lights.
Water protection system,is the anti flood device,fitted to machine base! Leak found,prob solved…thanks Martin
Latham63
ParticipantRe: Miele W2203 Washing machine.Flashing lights.
So the water protection system has activated.The manual advices calling service dept! Is there anything I can do about this?
Is it an anti flood abort mode,requiring presure bowl to be unblocked or pr. switch prob?Latham63
ParticipantRe: Bosch WTL6307GB Dryer No go
Thanks Martin,turned out to be heater NTC!
Latham63
ParticipantRe: Creda dryer T632CW No Sensordry
Fault found to be front thermostat above door!
Latham63
ParticipantRe: Bosch WTL6307GB Dryer No go
Do you mean the heater NTC?
Latham63
ParticipantRe: Hoover DM6211001 Vacuum cleaner,cuts out
Turned out filter inside dust pot compartment was blocked,causing restricted cooling air to motor.Even when filter was washed!
Latham63
ParticipantRe: John Lewis JLWD1404 Washer No Dry
Solenoid ok!
Latham63
ParticipantRe: Miele T294 C Dryer,stuck on finish
Simple solution! Select previous program,all is then well! Seems that if prog is disturbed or changed it will go to finish.
September 12, 2012 at 6:13 pm in reply to: Zanussi FLE1015W Washing machine-stops after wash #381044Latham63
ParticipantRe: Zanussi FLE1015W Washing machine-stops after wash
Me email is paul_latham@hotmail.com
With the led`s all lit when stopped it would appear to have aborted and gone back to the start?Latham63
ParticipantRe: Bosch WFT2800GB/13 Washer/Dryer No Heat
Ntc connector nipped up,problem solved! Thanks.
Latham63
ParticipantRe: Zanussi ZWD12270W Washer dryer. Cuts out
Late reply I know.Thanks for the details.The customer cancelled job in the end,after I`d given him a few hints! Suspect it was probably the dryer element.Had quite a few of these causing faults.
-
AuthorPosts
