Forum Replies Created
-
Posts
-
Re: reset one shot toc
I have reset them in the past but only if I have none with me, but you should always change them they only trip for a reason.
But saying that I reset the one on my creda dryer about 2 years ago and not since.
Think of it this way nice easy repair and a very small lay out on parts = HAPPY CUSTOMER 😀
Re: whirlpool s20drsb33 relay chatter and flashing inner l
In the past I have always just changed the rear but of late have had to change quite alot of front boards as well, even when upon checking says only change rear. Best to quote for both and cover yourself.
Re: Indesit Smart Card Reader
Yes you require a card reader and then the card for each machine. Only the problem is that we have been told you get one chance per card ??? not sure if this is right as I have not done one yet but we have been issued card readers. ❓
Re: Indesit To Close UK Service Down?
Possible if they got a BIGGER DISCOUNT on appliance purchases. ???
Re: New tool for dealing with water escapage
The mop ups are a good idea and work very well. I have been using them for about a year now great when the filter is blocked and you have to remove the hose etc put 2 down and they normally soak up most of the water then use another to clean up. The other good bit is I do not have to pay for them. 😀
Re: Samsung SR-S2028CSS NOT DEFROSTING
As per Samsung site:-
DA32-10109R Sensor
DA47-10148J Thermal Fuse😀
Re: Haier products
The reason the haiers are getting written off is down to poor supply of spares not due to the inability to fix them and yes they do have a high failure rate. Generally they require board and motor, so maybe cheaper to replace than repair ???
After the stuff they turn out you would have thought if indesit cannot get them to be of a quaility that is worth selling then why try ???
Re: Haier products
Error Codes for Haier washing machines as below:-
Err 1 – Door is not properly shut 20s after program has started.
Err 2 – Drainage error, water not emptied within 4 min.
Err 3 – Temperature sensor is not properly connected or damaged.
Err 4 – Heater may be broken.
Err 5 – The required water level is not reached within 8 min.
Err 6 – Motor spped error, it may be not properly connected or damaged.
Err 7 – Motor overheat protection or is damaged.
Err 8 – Water level exceeds protection value.
Hope this helps as you can expect alot of repairs they are really poor quality. 😀Re: Haier products
Would not have one as a gift !!! They have problems with bearings / motors and pcb………oh but the doors seems ok LOL 😈
Re: candy AQUA 1000T-80 module pcb
41011295 Coreboard 32K programmed
41011819 Electronic control 32K not programmed
😀
Re: Hoover HNT2135 Top Loader
They are not that bad to work on. Take right hand side panel off as you look at it and from memory most parts there.
Try removing heater and get to stuck item but usually door clips not fasten correctly.
The other thing you can try is removing belt and use brute force to turn drum.
Good Luck. 😀
