Forum Replies Created
-
Posts
-
Re: They dont build em like that anymore – Part 20
This came in have been looking after it for more years than i will admit 🙂
any one reconize this tumble dryer ?
and starters for 10 , whats this
found it in my store room still in its bag 🙂 seals and all 🙂 free to any good home that needs one :)…..
Re: Hotpoint DWF70S will not exit Demo.
Had one of these the same , would only reset with the door open , worth a try 🙂
Re: hotpoint mistral wiring fault
this may help sorry its not clear had it a few years
http://img31.imageshack.us/img31/2255/img264kr.jpg
i also emailed it to you ?Re: Hoover HED 8612 80 Dishwasher
The Water Load Phase was carried out until it’s reached the designed limit time of 7
minutes, due to a malfunction by the liters counter. All loads are turned OFF and a 60 seconds
drain phase is carried out. The buzzer sounds for 30 seconds and in this meanwhile, both pilot
lamps 1 and 2 are made flash together. Once the drain phase is ended, both pilot lamps 1 and
2 stay ON lighted fixed, until the moment the Dishwasher is powered OFF.pm your email addy and i will send you the test pdf
hth phil
Re: Hotpint FF91
Had one of these that drove me nuts ,bench ran the evap fan for 3 hours
no probs .put back on f/f , it went O/C when it was cold in the freezer …hth phil
Re: zanussi zx97/5si
possable causes fridge stat flap stuck shut, fan o/s , door switch faulty or door missalined, freezer avap frozen up , there a bit of a mare imo
hth philRe: Hoover D/W HFI3015/1-80 Reset
pm your email addy will send some light reading lol
count the flashes , it is a fault code …phil
Re: Hotpoint aqgmd129uk
THEMISTER FAULT . check dryer heater ntc , heater , ecetra……
filter may need cleaning
hth phil
Re: Hoover Oph7174D E03 fault help please
no probs fella.
have found changing the heater sorts it out, even iff theres no low insulation showing …
phil
