Forum Replies Created
-
Posts
-
Re: DHL and Their Lifestyle Couriers Grrrrr?
The quality of deliveries are all down to the individual driver, most of my are DHL, the usuall guy is top notch he even delivers without a signature when I am not there, very important when you a one man band.
Our post is usually prety good except on a Thursday when we get a right pratt, probably my mistake for asking to stop jumping over the garden wall and causing damage 😥 I have even put a note on the door asking him to take it next door, doesn’t take a s*hite of notice 😥Re: How much would it cost to make a Servis washer?
So why would anyone wan’t to make a Servis in the first place. 😥
Re: Just for the record..ouch!!!
So we are all making “safety zones” as laid out in bla bla regs are we ❓
Re: Driving standards!
iadom wrote:Not quite as bad as this jerk in Australia, drunk and showing of to the ladies. :rolls: Jim.
The Sheilas must have been pole dancers 😆
Re: prima/whirlpool dishwasher no heat!
Thanks All
I will give the NTC a go and see what happens, watch this space 😉Re: prima/whirlpool dishwasher no heat!
DentedPorsche wrote:Ntc reading seems a bit high. Mind you, depends on the temperature.
At 20 deg 58.1 kohm
25 – 47.1
30 – 38.2
40 – 25.4
50 – 17.2
60 – 11.8
70 – 8.3
80 – 6
85 – 4
BrianWater temp at tap. .is about 10c which by my calculation would give a reading about 90k, this looks ok 76k would be around 15c which is what it may have risen to after five minutes running when I tested it. 😕
Life was sweeter when we had timers and not all these micro processors :rolls:
Re: prima/whirlpool dishwasher no heat!
DentedPorsche wrote:Normally, if it completes the cycle with no errors it’s a software problem on the module. Changing the module would normally cure it. (Whirlpool engineer would rewrite software to module).
However, as you’ve already changed the module to no avail it really only leaves the NTC or wiring at fault.
To test the heater and wiring, disconnect at the module and test from there. You’ll test the wiring, TOC and heater in one.
Try running the diagnostic program and see if it throws up an error.Brian
Hi Brian
Yep done all the tests from the module, heater has circuit, NTC had a circuit, although it measured 76kohm,cold, I am not sure if this is normal or not 😕 Test prog. shows nothing, completes cycle same as on a wash prog.Re: prima/whirlpool dishwasher no heat!
I have had one of these today with the same fault, I was going to order a new user board(pcb) but after reading your diagnostics I am not so sure. 😕
This is a job for those Wpool. experts out there if you can help please :rolls:
Last week I had another Prima, faulty motor as usual but it had shorted and took out the user board 😥 15 months old ❗ Don’t you just love the quality 😥 sent the guy back to the retailer to complain about it, fit for purpose,
Re: ARISTON A1636 Strange wire
timdowning wrote:It has to be the motor earth wire. Was the motor earthed? If it didn’t reach the motor it may have been tied into the loom by a previous engineer who thought it was a spare wire?
Never been touched before, I am a bit reluctant to use a neutral as a earth.
Obviously I need a wiring diag, can anyone help please?
Re: Diplomat 8702 Dispenser hose
kwatt wrote:
maltheviking wrote:
Anyone got a part no. for the disp. to tub hose for this model please, there is probably a Servis/ Ardo/ Whirlpool equivalent, but I don’t know it 😳414006600 – RRP £4.91 exclK.
Hi Ken
Ordered one of these and received a length of hose suitable for valves to dispenser 😕 Have the wholesalers got it wrong? 😕
