Forum Replies Created
-
Posts
-
Re: Football 2015/2016
I think you mean the 2016-17 season Jim. Pogba was playing for Juventus last season.
Re: Bosch – water from matrix top vent
If you have very high water pressure you might try turning the flow rate down slightly. 💡
Re: Electrolux
Kevin Wheeler? Kevin Wheeler ? What is it you would want to know, does he owe you money, run off with your best friend? You can share it all here you know, I shan’t tell. 😉
Re: Service Washing Machine Repair
Have you tried entering your Postcode in the engineer search facility?
Re: Bosch – water from matrix top vent
The integral vent valve in the top left of the matrix could be clogged with detritus??
Re: Has don gone to the dark side?
Don is a smart cookie so I suspect he looked up the OP’s IP address then found it way out of his patch for a quick sale and hence recommended the market place leaders.
Re: Ripped off – Dodgy engineers?
Agreed, does sound like a new compressor will fix. Insulation issues, total ballcocks. But the good news is, in spite of two visits and a long time no fridge freezer, it has cost you nothing so far….or has it? 😕
Replacing a compressor on and integrated FF will be a costly exercise. So you might well be advised to avoid these ‘no fix no fee’ cowboys and go back to the manufacturers service partners (BSH) or a local bonefide independent repairer for their honest ‘over the phone opinion’.
Re: E03 error
A multimeter will not show up an earth leak, you need a 500dcV insulation tester for that purpose. But yes try safely removing the heater terminals should clear the error if that heater is the problem.
Re: E03 error
E03 is meant to represent that the draining time phase has been exceeded. However, if the drain is clear, the pump works OK and it empties quickly with no apparent reason for the error message, then it is time to check the heater. If the heater has the slightest leak to earth this will also throw up an E03 error.
I suggest you check out that heater. 😉
Re: Hotpoint WDd960 wiring help
Single colour wires on a connector block usually share the exact same connections at the other end of the loom.
Re: Bosch WVT1260 steaming
martfoxy wrote:Do the inlet valves get scaled up and reduce the water flow?
Yes they can do but in the case of the dryer/condenser valve it is only a small trickle of water that passes through constantly. As a rule if you have any flow at all then that proves that the inlet valve is OK.
…..and yes they do run warm, the coil does anyway.
Re: How much credit to extend to work providers?
Yeah this 30 day payment is an annoying fact of life but at least payment is pretty well assured. What niggles me is that tenants have to pay them 30 days in advance, so they have a good revenue stream coming in, and can keep back paying out for up to 60 days in effect. 🙁
