Forum Replies Created
-
Posts
-
Re: PCB Repairs
Good Lord yes, look in our “Web Links” in the navigation bar (Trade suppliers) 😉
They have been around for donkeys years…and very good too 😀
Re: Aristom Margherita LB12T
Throughout the product of that model no less than 7 different motors were fitted. All vary in price as a complete unit and all have differing replaceable brushes 😕
If you can advise us on the part you require that would be best 💡
Beyond that I would recommend getting an independent local expert in to look at it for you. Check this link for one in your area :Repairs@
Re: Mould in drawer of washing machine
Click on the link below for the answer:-
http://www.ukwhitegoods.co.uk/modules.p … age&pid=43Re: problem with ariston washing machine
If there is a fault with your machine usually the red light on the panel will flash rapidly in sequence to show the ‘error code’. (by counting the rapid flashes between the longer pause)
Beyond that, it really could be anything :con:
I would recommend a local independent repair call in and have a look at it for you via this link: Repairs@
Re: Indesit WD12 Bearing and Seal
If you provide us with the serial number of your machine you can order the Front and rear Bearing and the Water seal direct from us via emailing spares@ukwhitegoods.co.uk. Just add all the relevant details to your message and we can order what you require if you wish 🙂
Re: Indesit WD12 Bearing and Seal
You’ll need a T35 torx bit, heavy gloves and arm protectors 🙁
It’s a very tricky job where one could so easily damaged the outer drum as it is paper thin! If when you get the spigot off and you find the ball race has collapsed, then stop at that point and throw the lot in the nearest skip.
I would always advocate expert help to get the job done for you using this link for your convenience: Repairs@
Best of luck! 😀
Re: Smeg F64 oven door switch
A likely element failure and or door switch would need looking at for sure. Check Repairs@ for a local engineer to test it for you 😀
Re: Indesit WG1285W Carbons
There are 2 different motors fitted to this machine dependant on serial number. Most common though is C00035290 (Qualtex CAR67)
Re: AEG 40300 drain pump
I reckon it looks very much as if the Qualtex PMP230 (latest Bosch type) will fit it?
Perhaps Dave Conway can confirm later? Not sure about your Zanussi equivalent as I cannot find an illustration, sorry.
Re: CANDY ALISE 1200ES
Mark,
The illustration I have gives 2 differing part numbers for the same hose :con:
I have 92131234 and 92131705 both are listed as valve to condenser hose 🙄 …take your pick mate 😉
Re: door error
motorman wrote:any ideas
Please help us out on this motorman and give us a clue as to the make and model number of the troublesome machine?
There are hundreds of them out there after all 🙄
Re: Whirlpool awm5125/1 will not start a program
In fact any component within that is open circuit 🙁 Heater, valves etc etc
