Forum Replies Created
-
Posts
-
Re: bosch wte6920 belt fitting
Oh! Just realised. You don’t need to withdraw motor (only unless you change the small motor drive belt) the main drum belt goes around the secondary pulley. However best policy is replace BOTH belts as they wear equally.
Re: bosch wte6920 belt fitting
Should post this in trade tech forum. Mods please move it.
I’ve posted this answer many times I’ve lost count TBH. (sigh)
R/H panel, heater cover and lid off.
Remove nut holding on front fan.
Release tension spring, motor connector block and plastic latch to right of motor.
Release motor shaft clamp and withdraw motor and rear fan out of the back sufficient to thread drum belt into motor shaft.
Release enough screws securing rear panel and rear bearing circlip sufficient to threading belt around rear shaft and onto the tub.
Reassemble in reverse order.If I’ve overlooked anything I apologise as I’m replying to you whilst waiting for some twat of surveyor inspects a property I’m selling. He keeps interrupting my line of thought asking pointless questions :rolls:
Re: Best choice of single oven 60cm electric cooker?
I’d avoid the OTT one and the junk one and go for the Amica. It might well last 5 yrs then get that super new kitchen and bung in some good stuff like Neff.
Re: Best choice of single oven 60cm electric cooker?
Is this a spam post with all these links attached?
Re: Zanussi ZSF6161 problem?
It’s probably the drain off of a small amount of water from that reservoir. It should stop in a matter of seconds though. If not then prepair to man the lifeboats because the water inlet valve is not shutting off…!
Re: Zanussi ZDE57140W – 91609385702 Wiring Diagram
WhiteVanMan1 wrote:Thanks Martin. I’m guessing, but by a series error, do you mean a time out error? Steve.
No,errors in the E30, E31, E32 group series as per the ‘Known Error Codes’ thread.
Re: indesit washer door
Sorry to inform you then that you will not able to get one from here as that is against forum rules.
