Forum Replies Created
-
Posts
-
Re: ACA9102 Bottom Arm Not Rotating
maybe its a mechanical problem with the solonoid and its possibly stuck in the closed position, the only way to check that is to get off and have a look, that pcb sounds ok.
unplug from mains and have a look
Re: Smeg Dishwasher Model DW1614
E8 read error, rest and try again
Try dissconnecting from power supply for a good few hours
Re: white knight c/d WK767C
oh and I also just remembered, if the door is opened whilst dryer is heating this can also cause the toc to pop out. So if customer is checking to see if clothes are dry before its finished this could be the problem, it must be left to tumble cool. Its because when you open door the ement no longer has air being blown over it and because of the way these elements sit on the back plate the heat quickly disperses over the plate and causes the toc to pop out.
Re: white knight c/d WK767C
Particulary the exhaust thermostat which the one down bottom on fan duct
Re: New Baumatic BDI631 Dishwasher not starting
not sure how to use cancel on these but it is normally holding in a button for a few secconds wether that be the start button or the program button Im not sure on this have a read of book and it should tell you how to cancel and try that
Re: Servis M6713
give the door a gentle slam to make sure it is engaging interlock properly and try that
Re: Gas oven problem
its usually the flame safety device as long as thermocouple is in flame properly
Re: Diplomat D/W ADP8322 7 flashes
F7. 7 Flashes. Flow meter failure. Flow meter defect. Water inlet valve defect or water inlet hose blocked
Re: Bosch SGS45C08GB not draining
have you checked the end of the drainage hose especially where it attaches to under sink or blockages?
Re: Diplomat APM 8702 not spinning
mind you just take off the pressure tube from the switch at top and see if it spins then, cos if its still the the same then it probably is the module which is common on these, remember to unplug machine first
Re: Diplomat APM 8702 not spinning
pressure chamber is in the sump hose it has a small tube coming off it to switch at top, there is a clip on sump hose to remove the plastic chamber and clean out
