Forum Replies Created
-
Posts
-
Re: Whirlpool fault 3 flashes
F3. 3 Flashes. Heating system defect. Heater or relay on control board defect. Chack also cabling.
you need to check the heater first remember to unplug mains first
Re: please help
Probably the easiest way to see and access the resetable thermostat is by taking ogg the right hand side panel and then you will see it near the bottom red button. It can be done from the front but unless youve done it before it can be awkward because you can,t see it only feel your way in.
So i advise you take side off BUT UNPLUG MAINS FIRSTRe: Whirlpool adp8500 odd fault
Also have seen the insulation reading being low cause this on these dishwashers as well
Re: didplomat HJA 8630
yes that is a beko made dishwasher, have done a few mains switches on these also if the top corner screws in the facia which hold wooden door on are too tight then the mains switch will stick so check that first
always unplug machine firssssssssttttttttt
Re: whirlpool adg7540
looks like that switch is faulty, link below
http://shop.ukwhitegoods.co.uk/Dishwash … witch.htmlRe: HDA HJA8630 dishwasher
im sure that is the beko made dishwasher and id check the flowmeter on air break quite common with those symtoms
