Forum Replies Created
-
Posts
-
Re: AEG washer dryer – Timer resetting to zero on dryer prog
common for the condenser to block near the top as its very narrow there, in turn affects count down time or aborts
Re: Zanussi ZWF1621
Yes, It will be worth putting on the heater in diagnostics for a good while to see if earth fault is only developing when heaters been on for a good while or ask cust to put on a boil wash b4 you call
Re: Zanussi Washer Dryer (No Heat)
check the thermistor/connections . the one thats located at bottom of condensor or possible blocked condensor
Re: Whirlpool ADG644 Fault
F7. 7 Flashes. Flow meter failure. Flow meter defect. Water inlet valve defect or water inlet hose blocked.
as long as theres water coming in then itll be the flowmeter situated on air break left hand side
Re: cooker hoods
http://www.whirlpool.co.za/app.cnt/whr/ … odid/46262
Yes the supply is normally behind the chimney duct, should be two screws at top of this duct near ceiling and then it sholud come off, unless your unlucky and they have run a shelf and cornice across it
Re: Hotpoint DWM55 Tablet Release
Some of these dispensers are designed not to open fully so that they hold the tablet there enough for the jet on the top spray arm to dissolve it, so i would check for any food debris in the holes on the spray arms if theres any blocked then that will be your problem.
Re: Diplomat ADP8322
Ive had 2 or three of them do that in the past
fitted new elbow problem solved
WeirdRe: Diplomat ADP8322 giving two separate errors codes 6 &
it will be a faulty flowmeter, you can only but it with the air break complete its behind left hand side panel. link for part below
dont forget to unplug power before investigating!
