Forum Replies Created
-
Posts
-
When Hotpoint was a UK company they would have provided a kit with the new type pulley and a conversion sleeve.
If you are stuck Daniel I am pretty sure the pulley on C00165972 is the same.Murv…
Check for blockage in the hoses, pump and waste plumbing. If none it’s most likely the pump at fault.
Murv…
Rear fan off
Mark the position of motor end frame against rear plastic with a marker pen
Unscrew 4 motor screws and rotate it to release pressure on jockey
Fit belt and stretch it by rotating the motor back into position with a lever or pipe pliers
While holding motor in previously marked position refit the screwsMost likely a power module fault. Check the motor windings read the same value across any 2 of the 3 terminals (ie top to middle, bottom to middle, and top to bottom)
Had another one in on Saturday. Model WMXTF942GUK CC 080858880196 Serial 510…… with module C00305416 FW1:010100. Customer had removed filter to drain it down. Settings dump and reflash with skyprog cured it in a couple of minutes.
PCB senses damp clothes using a sensor strip at front of drum. I can send you service data, just need an email address.
Murv…This model looks like an experiment to see how many different parts in the factory can be turned into a wash dryer. I have come across 14 commercial codes some of which have both double and triple valves. Other differences include just about everything – plastic drum, weights, hoses, door seal, condenser, dryer assy, module, and plenty of software versions to control it all.
Murv…
Have come across some double valve W/D versions. Not sure if they can be tied down to a single CC, may be related to serial number? They use a standard unrestricted W/M valve, taking short bursts of water through the dispenser (often causing a thumping noise from the fill pipe)
Would be interesting to see a service manual if anyone can find one
Murv…
