Forum Replies Created
-
Posts
-
Re: Hpt SDW60 prewash light flash
PM me and I’ll send you the service manual…if you need any parts..I have one here for scrap as the heater has blown and the pump has cracked it locating lugs..other than that it good!
Martin
Re: Mile novotronic 500 Drain pump keeps running
Try a reading on the next setting down on your meter,but it sounds as though you have a open circuit (faulty) element…as for the small plug in connector,that is a NTC. Which basically reads your water temperature
When the heater is energised…Martin
Re: Miele W1613
Never actually worked on this Miele model,but usually it’s screws around soap drawer housing,bolts around door seal,and possibly screws underneath the front…top may also have to be taken off
Martin
Re: Mile novotronic 500 Drain pump keeps running
Set your meter to 200 on the ohms range..let me know what reading you get… Also try removing the small black tune that leads from the pressure vessel up to the main circuit board…remove from the circuit board and blow down it…there still maybe a small blockage…you will hear a gurgling sort if sound if all is clear…if its not your cheeks will inflate !!
Martin
Re: Mile novotronic 500 Drain pump keeps running
I think they will still work, but just wont heat the water…maybe some of the connectors to the heater have been disturbed or even not put back on? They are located at the bottom of the front of the drum, directly under the door boot…
Martin
Re: miele t230 dryer
Have you cleaned out th condesor unit itself, and not just the back of the housing..other than that you may have a leak in the drawer assembly or the hoses?
Martin
Re: Bosch WTE8630BGB/17 Dryer
I recall having that same problem a while back, it turned out to be either the heater relay or a capacitor that had domed on the main PCB.
Martin
