[nelson]

Re: Hoover VHD844DB80 stuck in fault mode

Actually Martin, you could well be right, the door did not lock but the door security led started to flash immediately on pressing the start button, which made me assume it was a fault elsewhere.
I think I’ll get a door lock and try that.

[nelson]

Re: Hoover OPH714 Door Gasket Problem

Just a thought, but have you checked that the drum shaft isn’t broken. I have had this a few times, and it could cause the drum to catch the seal.

[nelson]

Re: CDA cl 993 integrated washer dryer – Dryer dial

Thanks chaps

[nelson]

Re: Hoover HNL662 – 80 Drum spider

Cheers Suedehead1, 99 quid + VAT 😯 for parts I think this washing machine is now BER 🙁
Thanks for the info though :tup:

[nelson]

Re: Bosch WAE24162GB/03 Stuck on Heat even on rinses!?

Cheers Jem,
I’ll have a fiddle and see how we get on, I have the machine here in the workshop, the customer decided to buy a new one from me so there is no pressure to succeed, but it is in mint condition so seems a shame to strip and scrap it. I’ll let you know how I get on.

[nelson]

Re: Bosch WTL6305GB/01 no heat

Ok so I have replaced the NTC located at the front of the machine and now it heats but is barely warm :rolls:

I am wondering if the temperature limiter could be faulty http://www.bosch-home.co.uk/store/produ … ure/163297

but I am unsure what reading I should be getting from this.

Is this something that tends to go wrong or am I barking up the wrong tree?

[nelson]

Re: Reset procedure for Bosch WAA24171gb/01

Yeah after searching and not finding anything, I posted this and noticed it had already been done. My bad.

So it’s basically hold the start button turn one click anti clockwise hold for about three seconds then switch back to off position. Machine now reset. 🙂

[nelson]

Re: Whirlpool AWO/D4505 Drains but nowt else

Well I checked the heater and it was OK, so went through everything and eventually found a burnt component on the module.
I am not sure if these are repairable? But I think it will probably end up being replaced with a new washing machine.

[nelson]

Re: Whirlpool AWO/D4505 Drains but nowt else

Cheers Martin, I am going back today, I’ll check the heater first.

[nelson]

Re: Hoover Optima OPH714df-80 Program selector module

Cheers Martin, I will be sure to check the heater too.

[nelson]

Re: Whirlpool akp201/1x Oven

Cheers Johnmac11,

That’s doesn’t sound to bad. I’ll pass the info on.

Thanks again

[nelson]

Re: Whirlpool akp201/1x Oven

Cheers Don, I’ll get him to check

[nelson]

Re: Hotpoint Wf000 – All lights flashing

Cheers Jim, I’m going to try an other capacitor in and if it doesn’t work, it’ll be a phone call to EMW.

[nelson]

Re: Hotpoint 9404 twin tub

Thanks for that Jim, I’ll give it a go.

[nelson]

Re: Hoover HC6 150M – sticking during the rinse cycle

Thanks Martin & Don, I changed the selector switch and it worked a treat.

[Author]

Posts