[nelson]

Re: hotpoint WF440 doesn’t spin at the end of the program

Thanks for that steve, the customer said that none of the vertical leds were illuminated, only the horizontal leds with the exception of final spin???

[nelson]

Re: Indesit WIA101 – aborting wash

Thanks I’ll check it my self tomorrow 🙂

[nelson]

Re: Indesit WIA101 – aborting wash

The anti crease is one of two options, from left to right it would be no.2, then the wash light is one of three lights, no.2 from top to bottom and the door lock light is separate.

[nelson]

Re: hotpoint wd440 – F8

Cheers Chris I’ll check it out.

[nelson]

Re: Whirlpool sixth sense fault code????

I went back to this machine and checked the heater and wiring everything OK NTC seemed ok but I wasn’t 100 {e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} so ordered a new NTC. Fitted new NTC yesterday and machine filled up and started to wash, I drained it off and repeated on a few different wash programs all seemed ok (previously the machine starteded to fill then flashed F12). Good Times 😀

Got a call this morning, customer set machine on a wash after I left and 20 mins into the program F06. He then set the machine on to a rinse and spin program and got f12. Bad times 🙁

The model no. is AWO / D5506

Any help much appreciated 😕

[nelson]

Re: Ariston A1636S Wiring Diagram

It is black, so it must be the earth from the motor, just the colour catching me out thanks guys. 😳

[nelson]

Re: Whirlpool sixth sense fault code????

Cheers Greg I’ll have a look tomorrow. 🙂

[nelson]

Re: Whirlpool sixth sense fault code????

Sorry Chris, It’s a washing machine but I have not got the model number to hand.

[nelson]

Re: Bosch Exxcel wfo285sgb/01 skips spin

😀 Thanks again Martin, Stripped the motor down, dowsed it in WD40 gave my comm stick a bit of welly and hey presto motor back from the dead. Very happy customer 😀 😀 😀

[nelson]

Re: Bosch Exxcel wfo285sgb/01 skips spin

Cheers martin, I’ll give it a try.

[nelson]

Re: Bosch Exxcel wfo285sgb/01 skips spin

Thanks Gegsy & Micky,
I checked the brushes the first time I called out and they were ok. I think I’ll see if I have a motor in the work shop that I can plug in and try before I order a new module.
Thanks again.

[nelson]

Re: Hotpoint Washer Dryer WD63 Eating TOC Kits

cheers fellas I’ll check that wiring.

[nelson]

Re: Indesit WIL103 Not sure of Fault code

Cheers Chris,

Called out to the machine yesterday, turned out to be 3&4, checked resistance on the thermistor, it was ok, so I tightened the pins on the connection and bingo it started up no lights and ran fine. Must have just been a bad connection to the thermistor.

Thanks again.

[nelson]

Re: Bosch integrated condenser dryer WTE6920

Thanks fellas, sorry I’ve been out of commision for a few days, so I’ll try your suggestions.

Cheers

[nelson]

Re: Wiring Diagram for a Servis M3024/M

Thanks Ian I got that. 😀

[Author]

Posts