Forum Replies Created
-
Posts
-
Re: Servis dishwasher impellor
You might like to check out 720054000 from Masterpart – £55, listed for your machine.
Chris.
Re: Bosch SPS 546, heating during wash, not during dry cycle
Not that we know of – have a word with admin@ukwhitegoods.co.uk about getting a commercial forum created!
The Mrs accidentally booked me an Aristoco (?) commercial d/w on Friday and I managed to fix it. Gawd knows what I’d have done if I’d needed parts for it! Room for a bit of pooling of knowledge perhaps.
Cheers,
Chris.Re: Bosch SPS 546, heating during wash, not during dry cycle
This one is a switch bank selector/electro-machanical timer controlled machine. Selector switch and n/o thermostat likely culprits, possibly timer fault.
Good luck,
Chris.Re: Baumatic b180ss fan oven element
Dave………
Looks like Bryan and I both need a fan motor for this one. Any idea about part number?Chris.
Re: SMEG DISHWASHER
The water level safety switch has been activated, therefore the machine is not detecting the water level correctly.
Engineer time…………. click the link below.
Regards,
Penguin45.Re: bauknecht wae8987
P/no 4812 466 68557. Email to spares@ukwhitegoods.co.uk for ordering and prices.
Regards,
Penguin45.Re: ASKO spares
Armstrong at Newbury were good for “proper” Asko spares – 01635 33881.
New stuff is through Servis IIRC.
Chris.
Re: Fisher & Paykel GW611 no drive??
Being merely Avian, I have sent for a higher authority – bear with us!
Penguin45.
Re: Diplomat ADP8101/2 integrated dishwasher
This is most likely a “no heat “problem – thermostat must click over at wash temperature to reactivate timer. Likely causes heater failure, stat failure, wiring failure, or safety tripped out.
Awkward machine to try and work on – you may want to consider pro help – click the link below.
Power off if investigating for yourself.
Regards,
Penguin45.Re: smartdrive 053
The machine will definitely not spin if the lid switch is not functioning. It should not revert the programme back to start however.
I’d run the diagnostics, see what comes up and report back.
Regards,
Penguin45.Re: Bosch WFB 2005 washing machine – doesn’t spin
Two different motors fitted on this range – a Siemens Bosch motor, brushes are £23 + VAT and an FHP motor, brushes are £29 +n VAT. Your engineer will charge you for a hours work as getting the motor out in the first place can be quite a struggle. Labour rates vary across the country, so this should be discussed at the time when you make your appointment.
Click the link below for an engineer in your area.
Regards,
Penguin45.Re: Fisher & Paykel GW611 no drive??
It’s probably the Rotor Position Sensor playing up. These are prone to corrosion and wiring problems. It can also be the Motor Board, which is expensive, so keep your fingers crossed…..
Power off if going into the motor.
Powering off should take you out of diagnostics……….
Regards,
Penguin45.
