Forum Replies Created
-
Posts
-
Re: Candy CN450 Washer. won’t hot fill or spin.
Power off and resistance check on the valve solenoid is the place to start. You should get 3.5kOhms approx. If you do, the fault will be the pcb. Double check the wiring, just in case.
Penguin45.
Re: teka (again) ADW6 59 FI VR02
Outline article HERE.
Inlet valve will sub for the dispenser solenoid for testing purposes.
Reset procedure is in Known Error Codes (P3). To turn alternator valve on, press Start button again and left hand light will go out.
Penguin45.
Re: replacement for AEG Santo 3049i
The Don will be able to advise you in the morning – he’s the retail Guru.
Penguin45.
Re: Bosch exxcel 1200 (WFO2465GB) – stays on wash cycle…
Had a few recently with burnt out connectors – wiring repair sorts them. What was wrong with proper AMP tag connections anyway?
Penguin45.
Re: Indesit w123 – Power lights but nothing else
More likely to be THESE ONES if it’s an Indesco motor.
Have you checked that they are worn out?
Penguin45.
Re: Hoover WM120M UK Washer/Dryer
Lock pulley with hammer handle into tub moulding. Undo nut, remove pulley. Refit nut to protect threads and belt the end of the shaft with a very large hammer.
Subtlety will get you nowhere….. I would advise eye and hand protection.
Penguin45.
Re: Diplomat ADP8242 Fault code
SMEG error code are in the Known Error Codes thread above. The lights lit do not conform however – possibly a corruption issue.
Chris.
Re: DI612C dishwasher clicking, beeping, and juddering
You’ll be back inside three months……. It’s the solenoid which corrupts the computer.
Chris.
Re: Problem with door seal gasket (spout)
The spout should be open to allow the bottom of the door seal to drain. Gum or sealant is used to seal the spout to the front of the tub. We use THIS STUFF.
Penguin45.
Re: hotpoint dwf 35 cycle problems
Can you post up all the numbers in the etched panel on the the top edge of the door? There might be a way to save you a few bob.
Penguin45.
Re: Smeg DWI612C PCB
Run away fill is a board corruption issue. P/no is 816290672, an email to spares@ukwhitegoods.co.uk for prices and ordering.
Be very sure that you wish to proceed – SMEG parts are not cheap.
You might also like to have a read of THIS ARTICLE.
Penguin45.
Re: Hotpoint FDW60 door catch
C00195887 is the part number. Email to spares@ukwhitegoods.co.uk for prices and ordering.
Penguin45.
