Forum Replies Created
-
Posts
-
Re: Neff U1721
Sadly, fan oven elements live short violent lives – there’s an article about them HERE. As you have got through a number of them quickly, there may be other issues. Fan motor not running at full speed, thermostat cycling incorrectly and buying pattern replacement elements can all be the cause of failures.
Penguin45.
Re: INDESIT WIDXL 126 Lights and 3 flashing
despairing wrote:It’s brand new! What could be wrong with it?!
It’s an Indesit……. lights 2+3 flashing is a “non-assigned” code, so it sounds like a corruption issue with the computer board.
Penguin45.
Re: Bosch SGV4313GB/17 Flooded base
The black bit in the middle is missing from yours.Replacement assembly is p/no 263186, from HERE.
Penguin45.
Re: electrolux EW1200i
That pnc no. uses a combined timer/module unit called a VS80 – p/no 1320558-12/3.
Chris.
Re: F&P error code 107
Water level control issue – transducer (level switch) is not detecting a change in water level in the time allowed. Pobable cause is the air hose to the switch becoming detached or holed; possible that the transduced has failed.
Penguin45.
Re: Candy CM126 leak
Dispenser to tub hose blocked with concreted soap powder is a common problem on these.
Penguin45.
Re: Which Vacuum Cleaner?
madrat wrote:You don’t get that problem with a Dyson. you just tip the cr#P in the bin and off you go. All other bagles cleaners are totally rubbish and clog in no time.
Que?
:p45:
Re: BEKO CERAMIC HOB DC5442W
I can’t give you a specific answer, but it more or less has to be a wiring issue. Power off, lift top and have a good look for burnt-out wiring.
Penguin45.
Re: Whirlpool ADP5966 Dishwasher with Rinse Aid Drink Proble
From memory (Haven’t done one for a while….), it’s just the side screws to release the door outer.
If you run the machine without the door panel there are exposed electical terminals, with obvious implications – I wouldn’t like you become DadOfManyMinus One……..
The Forum Rules at the top of this Forum are quire explicit – we will not advise on or advocate live testing under any circumstances.
Penguin45.
Re: Baumatic BDW13 error E1
Water valve failure is quite likely if you are sure that the supply is reaching the machine. With the power off, use a test meter to check the resistance of the solenoid coil on the inlet valve. You should get approximately 3.5-4kOhms reading.
Penguin45.
Re: Spam
ship–@flurostationDOTcom must be the most be one of the most detemined spammers we’ve ever had – thrown out 23 times now!
Chris.
