Forum Replies Created
-
Posts
-
Re: hotpoint wd62 washer/dryer
Broken wires to blower motor, heaters; chaffed loom at motor, side of casing; elements down to earth, s/c inlet valve, wind blowing from the south………
Chris.
Re: Prima LPR600 not pumping during wash
As far as the computer is concerned, there isn’t a fault. If you read the article, you will realise that the replacement unit is completely different – it’s a one time fix and you’ll get no more bother with it in the future.
Penguin45.
Re: BOSCH SGS5302GB/07 abnormal noises
Ignore the goo in the top of the matrix – it’s irrelevant to your problem. We are both suggesting that the machine is not taking in enough water. The water level should be half way up the salt cap in the base of the machine after the fill sequence completes.
The usual reason for the machine to under fill is either the chamber pictured or the hose coming out of the bottom of it getting partially blocked with sludge.
The matrix will unclip and lift away, the pressure chamber pulls up and off with a bit of a wiggle and the bottom hose will simply pull out sideways. See what’s in there, please.
Penguin45.
Re: ukw parts price runner ?
I think you’ll find that Dave is snowed under….
The oddball stuff that I’ve needed actually ordering, I’ve always just trusted Dave to get it!
Chris.
Re: Hotpoint WF860 loud thumping on fast spin help
This:
was once a £2 coin. It destroyed a plastic-tanked Servis automatic. We never did find the middle bit.
Anyway, makes a nice keyring.
Penguin45.
Re: BOSCH SGS5302GB/07 abnormal noises
Right. Remove the l/h side panel, you’ll find this:
The water level should be halfway up the salt cap, if the unit in the picture and the hose coming out bottom right ard full of congealed goo, it will underfill badly, then strange things happen……….
Strip and clean; try again.
Power off first.
Penguin45.
Re: EQUATOR EZ3612CEE malfunctioning – wash timer is rotatin
Hmm…… Indesit-build perhaps?
When the dial starts clunking round, check the start lamp and see if it flashes in a pattern, ie 1-2-3-4-pause-repeat. This is an error code and we may be able to work something out from there.
Penguin45.
Re: Hotpoint VTD20 tumble drier.
A1engineer wrote:use the hotpoint belt tool which is essentiallty the same,
Part No: 5600266 if you want one?:DChris.
Re: BOSCH SGS5302GB/07 abnormal noises
Lift latch on one side, give lid a thump to the rear, then do the other side.
Penguin45.
Re: Fisher & Paykel smartdrive 608 Not filling or agitat
Aha! The good old ‘out of balance’ switch fault. Top deck off, switch attached to the pendulum. It suffers from corrosion and damp as well as rotten wiring. Make sure that the bias spring is attached to the tub whilst you’re in there.
Power off first……….
Penguin45.
