Forum Replies Created
-
Posts
-
Re: Hotpoint Aquarius FDW60 – “Prewash” light flas
PCB should be p/no C00143209 for that serial number.
Penguin45.
Re: Zanussi 1397 spin/no spin problems
There are two air chambers on most of these. One is in the side of the top of the sump hose – split the casing to access. The other is part of the box which the filter fits into. It is retained by snap-in lugs through the floor of the machine and it’s really, really awkward to remove.
Penguin45.
Re: Cable WDI1210 not releasing water after cycle
Caple….
The filter behind the kick board at the bottom will be blocked. Drain the machine manually and unscrew the filter – check right back into the pump chamber with a torch.
Penguin45.
Re: Zanussi DCS 12W – Tabletop Dishwasher Not Draining
Presumably the drain pump is blocked or has failed. The panel underneath can be removed to access the drain pump.
Power off first.
Penguin45.
Re: Whirlpool ADG7440 tripping fuse
kevibo wrote:But why would the drip tray be so full of water?
THIS, usually.
Penguin45.
Re: BEKO D533 – Main oven not working
If the oven won’t do anything, there is probably a fault with the selector switch/thermostat unit in th econtrol panel. Top deck off to find out.
Power off first.
Penguin45.
Re: ZKG5540XN Main oven door glass
Well, only 4 to choose from…..
3491047068 – M/O outer
3491566026 – M/O inner
3491045096 – T/O outer
3490030016 – T/O innerChris.
Re: Bosch WFF2001 will not spin
New brushes may not have bedded properly, quite possible that the armature has exploded. Start with the motor….
Penguin45.
Re: Hotpoint Aquarius FDW60 – “Prewash” light flas
Full model details can be found on a label on the edge of the inner door panel.
Penguin45.
Re: Hotpoint Aquarius FDW60 –
£105 and The Indesit Company is all yours. They will try and sell you an extended warranty when you make the call….
If you are reasonably confident with your own ablility, the pcb/thermistor is £40-55 depending on the serial number, the latch unit is HERE at under £8.
Penguin45.
