Forum Replies Created
-
Posts
-
Re: Whirlpool Dishwasher ADG450/05 Water Heater
Just find a proper wholesaler and stop stressing about it.
266196 is under £52 from Masterpart.
Chris.
Re: Bosch SGI3305GB – not cleaning – pumped water pressure l
The correct water level in the machine is about 1/3 – 1/2 way up the salt cap on the floor of the machine. Check that first. Assuming that that is correct, the circulation pump may be running slowly (unlikely). The circulation pump impellor may be damaged or partially detached (happens, not often) or there is a physical obstruction somewhere in the pipework.
If the water is running freely into the machine during the fill sequence, the red float should not be operating the flood protection microswitch at all. This turns on the drain pump and removes water from the machine.
Hope that makes sense,
Penguin45.
Re: Candy dishwasher CDI1012
Difficult one to give a straight answer to. It could be as simple as the door switch not functioning; on the other hand, I have seen the pcbs on these reduced to carbon… (It wouldn’t programme at at all, mind you). Short of you getting the screwdrivers out yourself and seeing what’s going on, there’s not much I can tell you.
One of the pcbs is in the SHOP, which will give you some indicator on price. However, there are four UK versions of this machine and several different pcbs depending on the serial number.
You need to be very sure of the fault before trying to resolve this yourself.
Stay safe, power off if you intend to investigate the insides.
Regards,
Penguin45.
Re: Dishwasher won’t circulate
Nope, Whirlpool clipped them to the Askoll motor in the full knowledge that the replacement (metal framed) motor had to be earthed. It’s a piggy-back connection, so attach both to the terminal on the motor frame.
Penguin45.
Re: Bernstein 05 608107
P/no 01A951. Looks like special order everywhere. Drop spares@ukwhitegoods.co.uk an email – if Dave can’t fnd it for you, it isn’t out there anymore.
Penguin45.
Re: Whirlpool AWM328/3 Bearing Kit and Tub Seal
PM to Dave_Conway with the part numbers required will do the trick…….
Chris.
Re: Electrolux W355h
Try this one:
http://spc.els.electrolux.com/elux_public/
With thanks to Dave Conway.
Chris.
Re: Dead LG
richy wrote:was in the first post
Yes, it was, wasn’t it? Sorry about that.
Sounds like the power supply on the pcb has conked to me.
Chris.
