Forum Replies Created
-
Posts
-
Re: Leisure classic 110 – Both ovens dont heat up – pleasehe
Ron,
Appreciate your difficulty, but I have to point you to THIS STICKY.For the safety of you and your family, you must get this investigated professionally.
Penguin45,
Moderator.Re: teba a02004-01c
Teba….. Bust. No parts, no support, no nuffin.
Sales are on – good time to buy an oven.
Penguin45.
Re: Replacing bearings on Miele W919
It’s easier to get information out of the Masons these days…
:p45:
Re: whirlpool awo/d 4505 service light coming on/violent sha
The machine should fill, then start to tumble gently. If it fills then starts banging about violently, the motor will be running without speed control. This could be down to the tacho (feedback) circuit in the motor; broken wiring (common) or a pcb problem.
If it only does it on the spin sequence, I’d be looking for a blockage.
Power off if you intend to work on the machine yourself.
Penguin45.
Re: big w/pool t/drier parts needed
This came up before…
I *think* you need:
4819 528 88108 – pulley
4819 404 79189 – bracketChris.
Re: Whirlpool ADG722 – Continuous Flashing
NTC (temperture sensor) fault – you’ll need one of THESE.
It’s the finger sticking up in the sump and is a twist-fit from underneath.
Given the time of year and the extreme cold, if your kitchen is too cold you may get this fault. Try pouring in a jug of hot water a few minutes before setting the machine off – you might just hit lucky.
Power off if you decide to change the sensor.
Penguin45.
Re: Cda 496 beeping
CW496?
If so, it’s a Whirlpool-built machine. Four flashes means drain not detected in the time allowed.
Penguin45.
Re: In search of the fourth cord
I can only assume he lives in a house without windows… You guys are getting more than we are and we’ve had another 3″ tonight down here.
Out again tomorrow.
Chris.
Re: snowed in !!!
My Scud hasn’t got any clever gizmos, just my feet.
I’ve got stuck once so far and it took about 10 minutes to get out of it.
Fun job so far was out on a farm past North Rigton. Phoned customer to sat that I was on my way – turned into farm track to be faced by the back of a large tractor and a bloke holding a chain…. We got there. Fixed it, then he dragged me back down the track. Paid up without any complaints as well – nice.
Chris.
Re: Fisher and Paykel Smartdrive 603 Problem
Hi Leigh,
Not sure about the shortform for the codings you’ve put up – have a look at the top of the forum and try the diagnostics we’ve posted.
Initial thoughts would be a valve problem…
Penguin45.
Re: Indesit WIXL143 – Drum Leak
Yup, welded tub. No hose connections in that area, so I’d be looking for coin damage.
Don’t waste too much time on it.
Chris.
Re: Servis M6725s
PCB, PCB, PCB and possibly, PCB?
Typical – they’ve bought it cheap after the collapse, now the want to do SOGA. Personally, I wouldn’t get involved….
Chris.
