Penguin45

Forum Replies Created

Viewing 15 posts - 1,396 through 1,410 (of 19,678 total)
  • Author
    Posts
  • in reply to: Tricity Bendix TM310W No Heat #306421
    Penguin45
    Participant

    Re: Tricity Bendix TM310W No Heat

    Thermostat up the inside of the front of the tub is the usual culprit.

    Chris.

    in reply to: Wirlpool AWO/D 4505 – Fault code? #305875
    Penguin45
    Participant

    Re: Wirlpool AWO/D 4505 – Fault code?

    Done.

    Chris.

    in reply to: AEG W/M needs configuring #306413
    Penguin45
    Participant

    Re: AEG W/M needs configuring

    File in your In-box.

    Chris.

    in reply to: nardi ek9558 3 AX #306408
    Penguin45
    Participant

    Re: nardi ek9558 3 AX

    050442009904R – gas tap
    050442009905R – gas tap – rapid
    050442009906R – gas tap – ultra rapid

    All POA at Masterpart.

    Chris.

    in reply to: hvl211 fault code #306391
    Penguin45
    Participant

    Re: hvl211 fault code

    F12 – comms error between pcbs.

    Chris.

    in reply to: Candy CD112 Dishwasher motor???? #306393
    Penguin45
    Participant

    Re: Candy CD112 Dishwasher motor????

    Wash motor now 49017691 – conversion kit.
    Drain pump is just the usual Askoll type.

    Chris.

    in reply to: ADG7540 Not Cleaning #305705
    Penguin45
    Participant

    Re: ADG7540 Not Cleaning

    Possible, but unusual on these………. Up to you to strip it down and find out, though.

    Penguin45.

    in reply to: Zan W/D ZWD 16270W Thermistor Plug? #306346
    Penguin45
    Participant

    Re: Zan W/D ZWD 16270W Thermistor Plug?

    One harness feeds (top) front thermistor and (lower) duct thermistor. Basically, four bits of cable, one plug at one end and two separate ones at the other.

    Chris.

    in reply to: White westinghouse washer dryer motor #306277
    Penguin45
    Participant

    Re: White westinghouse washer dryer motor

    Siltal – p/no 49558800.

    Chris.

    in reply to: Zan W/D ZWD 16270W Thermistor Plug? #306344
    Penguin45
    Participant

    Re: Zan W/D ZWD 16270W Thermistor Plug?

    1324405-11/5 is the harness to both thermistors.

    Chris.

    in reply to: ADG7540 Not Cleaning #305703
    Penguin45
    Participant

    Re: ADG7540 Not Cleaning

    webby54 wrote:Oh, how could I test the motor to confirm it’s kaput?

    Wait for it to fill, give it a minute, then open the door quickly. You should get slightly wet and see water spraying…..l

    Replacement is HERE.

    Article about the iniquities of The Big Askoll motor can be found HERE.

    Penguin45.

    in reply to: Baumatic DW Over Fill #306196
    Penguin45
    Participant

    Re: Baumatic DW Over Fill

    Just a Chinese dishwasher – inscrutable. And junk – I wouldn’t get too involved.

    Chris.

    in reply to: AEG Lavamat 6100 Digitronic Drum Bearings #305719
    Penguin45
    Participant

    Re: AEG Lavamat 6100 Digitronic Drum Bearings

    One of your bearings isn’t fully driven home.

    Penguin45.

    in reply to: CANDY CS455MS SLIMLINE DISHWASHER #306166
    Penguin45
    Participant

    Re: CANDY CS455MS SLIMLINE DISHWASHER

    Drain pump will be running because the flood protection system has been activated by the base tray filling with water.

    Power off, towels down, lean the machine over to one side at a good angle and wait for the water to stop. If it dioes it again, you’re playing “Find the leak”; a popular pastime with Chines dishwashers.

    Penguin45.

    in reply to: Hotpoint Cooker Error Codes #306149
    Penguin45
    Participant

    Re: Hotpoint Cooker Error Codes

    No heat detected in the time allowed.

    Chris.

Viewing 15 posts - 1,396 through 1,410 (of 19,678 total)