Forum Replies Created
-
Posts
-
Re: Hoover HEDS668-80 dishwasher
Chinese tat. Probably the flow meter, although the lights suggest time-out heat.
Chris.
Re: matrix?
If it’s a Chink, it’s F5 – overfill/flood, if it’s a Fagor Brandt, it’s time out on fill.
Chris.
Re: Whirlpool AWM 8123/S Door Lock
Self diagnostics on start up is the answer. It will run the drain cycle because no motor action is required on that programme.
Penguin45.
Re: Error code E20 on Zanussi ZWD 1471S
True, but good practice would be to split the casing and clean the condenser housing anyway.
Penguin45.
Re: Swan microwave SM2060 tripping RCB
Public forum, Tiprat – no-one’s going to discuss a safe method of dealing with 4.5kV.
Penguin45,
Moderator.Re: Diplomat APM8512
Ensure that you have plenty of belt tension, then try with a full load. The out of balance system is notoriously sensitive on these machines.
Penguin45.
Re: Crusader gasping for breath
Rear bearing can be seen by removing the small cover in the centre rear of the machine. For everything else, remove lid and r/h side panel. Motor bearings, fans and worn carriers can all generate interesting noises.
Power off first, of course.
Penguin45.
Re: Hotpoint TC71P condenser drier
Replace the pin on the door – p/no C00165923. I think they have made it slightly longer as the door warps with heat.
Can’t see the facia panel clips listed anymoer.
Penguin45.
Re: Whirlpool error
European model – we do not have tech info for this machine. Assuming the coding system is standard, 12 flashes = code FB, which is the diverter valve failure code. This is a device which alternates the water between the top and bottom spray arms.
Hope that helps,
Penguin45.
Re: Pumps in a Dishwasher
It’s a 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} US appliance, Pancho; we can’t tell you much about it. However, our American friends over at http://appliancejunk.com/forums/ will be able to advise you.
Penguin45.
