Phidom

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 1,873 total)
  • Author
    Posts
  • in reply to: Tricity bendix SE340W cooker #354168
    Phidom
    Participant

    Re: Tricity bendix SE340W cooker

    What did it trip, the cooker mcb or the main RCD? If it was the RCD it might be worth a Megger test on the ring insulation when you fit the new energy regulator.

    in reply to: 1/4″ Olive #354150
    Phidom
    Participant

    Re: 1/4" Olive

    Thanks Bryan. 🙂

    in reply to: Cheap Printers #353626
    Phidom
    Participant

    Re: Cheap Printers

    My first inkjet printer was a Xerox but it was unreliable and not many places stocked the ink. I actually picked up a factory return one of the same model as it came with unopened inks and only cost about the same as a set of genuine inks. I set it up and it was much faster than the first one, which had been painfully slow.

    in reply to: Cheque guarantee scheme ending soon. #343799
    Phidom
    Participant

    Re: Cheque guarantee scheme ending soon.

    I never bothered taking card details anyway with cheques and never had a bouncy one in 14 years of trading. This move does represent the beginning of the end for cheques though and is one of the reasons I’m leaving the trade.

    in reply to: Propane Gas Cooker #353535
    Phidom
    Participant

    Re: Propane Gas Cooker

    Thanks. I’m thinking in the short term I might just take the cooker out of my camper van and set that up.

    in reply to: Propane Gas Cooker #353533
    Phidom
    Participant

    Re: Propane Gas Cooker

    Those are for LPG, is that the same?

    in reply to: Zanussi Bearing kit #350278
    Phidom
    Participant

    Re: Zanussi Bearing kit

    Thanks, I think I have it sussed now and I’m hoping I can use a seal I got for a Hoover machine.

    in reply to: L.G WM 1285 FHD Constant pumping. #349901
    Phidom
    Participant

    Re: L.G WM 1285 FHD Constant pumping.

    I know they are a pain to work on as the board is buried in silicone but it might be possible to trace the wiring from the pump to a component on the board which reads short circuit. Otherwise you could try QER.

    in reply to: Van Insurance no claims discount #349175
    Phidom
    Participant

    Re: Van Insurance no claims discount

    Surely the one with the Meriva should not have affected your NCB as your insurer should have claimed from the driver at fault?

    in reply to: Zanussi Motor Star washer for tacho #349845
    Phidom
    Participant

    Re: Zanussi Motor Star washer for tacho

    I’ve sometimes used silicone sealant to glue the coil back in and instructed the customer to leave it a few hours before running the machine.

    in reply to: HOTPOINT WDL 520 not drying properly #349384
    Phidom
    Participant

    Re: HOTPOINT WDL 520 not drying properly

    iadom wrote:

    Phidom wrote:
    There is not that much to go wrong on these dryer systems.

    This is a totally Indesit designed dryer assembly, everything goes wrong with these, TOC’s, NTC’s, fans come loose, filters clog, elements fail for fun, they are just C**P.

    Jim.
    What I meant was, if there is drum rotation, air circulation, air heating, a suitable trickle of water to condense the water vapour and adequate pumping it will dry the clothes. Any of those functions can fail but it’s not rocket science to check them all.

    in reply to: HOTPOINT WDL 520 not drying properly #349378
    Phidom
    Participant

    Re: HOTPOINT WDL 520 not drying properly

    I’m not familiar with that model but usually the condenser is a plastic moulding that goes from the fan area at the top of the machine to feed into the back or side of the tub fairly low down. In such cases I would remove the condenser and wash it out to remove any fluff.

    in reply to: HP Wireless Mouse #349523
    Phidom
    Participant

    Re: HP Wireless Mouse

    Still no joy so I will have to go back to Tesco….again.

    in reply to: Van Insurance no claims discount #349172
    Phidom
    Participant

    Re: Van Insurance no claims discount

    Insurance firms can say whatever they like and there’s nothing you can do apart from take your business elsewhere. This business of having to accumulate NCB on each individual vehicle is a rip-off, pure and simple. It should be a discount for careful drivers, if you drive one van carefully are you going to drive the other van wrecklessly or what?
    I just changed my van from a small Vauxhall Combo to an LDV LWB Hightop Convoy. I was charged £200 extra on the LDV, the original premium on the Vauxhall was about £210 so it is almost double 😯 . I queried this and was told it was because the LDV has a bigger engine (2.4 as opposed to 1.3). This seems utter nonsense to me as the Vauxhall is a much faster van than the 3.5 tonne LDV.

    in reply to: HOTPOINT WDL 520 not drying properly #349376
    Phidom
    Participant

    Re: HOTPOINT WDL 520 not drying properly

    Have you checked for fluff build up in the condenser? There is not that much to go wrong on these dryer systems.

Viewing 15 posts - 16 through 30 (of 1,873 total)