Forum Replies Created
-
Posts
-
Re: Bosch d/w pcb blown
It’s not just the built in, quite common but its a triac they blow.Not sure about a resistor.?
The other thing that will cause a triac to fail is the motor on the heater. This is obviously a different triac so you need to check!! 😉Re: Bosch dishwasher
1min means the appliance has not reached heating temp in time/ not heating at all 😆
Re: bosch dishwasher
I’ll agree with Jon. IF memory serves me right you can bypass the small delay pcb. It’s been a while since i have had to do it but I’m sure there are two wires of the same size and colour, if you short them out the m/c will fill passing the time delay pcb. Obviously proceed with caution but its fairly logical when you look at the wires
Re: Bosch error code
‘e2’ is fridge evaporator sensor i thought? not a replacement part. If you fit a new main pcb [behind the facia] that cures the problem [sensor bypass sort of thing]
Re: Neff H7860N1GB/01 FD7902 microwave temp dial not moving
Same sort of ribbon indicator that was fitted on the ovens [151479] Rather fiddly but that’s all you should really need.
Fascia hinges down once you remove the screw hidden behind the top vent[vent just pulls out] Slightly move fascia to the right. It is possible to do it in situ with out taking off the main cover but if you have never done one it might be worth taking appliance out of housing [ remember to eat you weetabix!!! ]
Lots of parts now n/s with this appliance!! 😥
Re: Neff V4380X0 GB/13 Suspension Spring
Plastic coated cable. Loop it round the top of the spring, Lift into position. Pull out cable. Job’s a good en! 😆
