PINKY

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 260 total)
1 2 3 … 16 17 18
  • Author
    Posts
  • April 20, 2015 at 7:21 pm in reply to: Siemens SN66T095GB/70 Fault code 04 &31 #424092
    PINKY
    Participant

    Re: Siemens SN66T095GB/70 Fault code 04 &31

    Depending on the fdt its a problem with the zeolith heater and fan.. the cap on the heater doesnt fit properly. You end up with water in the fan and a blown heater. Job for warranty. Loads of money and a findly job

    August 22, 2014 at 1:35 pm in reply to: bosch waq 24460gb01 f18 #418166
    PINKY
    Participant

    Re: bosch waq 24460gb01 f18

    Blocked pressure chamber?

    February 6, 2013 at 7:17 pm in reply to: Filippi Factory #386707
    PINKY
    Participant

    Re: Filippi Factory

    Basic salaryof 19k!! Mmmmm!! That will be no thanks then

    February 4, 2013 at 7:57 pm in reply to: Filippi Factory #386705
    PINKY
    Participant

    Re: Filippi Factory

    There advertising for engineers. Are they any good to work for???

    October 28, 2011 at 3:17 pm in reply to: BOSCH WASHER EXXEL 7 #362400
    PINKY
    Participant

    Re: BOSCH WASHER EXXEL 7

    Child lock on? Press and hold start button for 10sec or so

    October 27, 2011 at 4:25 pm in reply to: Bosch dishwasher SGS43A12GB/27 #362104
    PINKY
    Participant

    Re: Bosch dishwasher SGS43A12GB/27

    Just get them to call Bosch back. Its unlikely the mod was carried out by a Bosch engineer. With out a doubt has not been coded properly

    October 27, 2011 at 4:21 pm in reply to: Beeping Bosch #360663
    PINKY
    Participant

    Re: Beeping Bosch

    He would not have ‘plugged his laptop in’! The software does not yet support this.
    Checked out repair instructions on lap top maybe. Poor service though

    Pink..

    October 11, 2011 at 8:41 pm in reply to: Siemens Washing M/C Heating Problem? #360327
    PINKY
    Participant

    Re: Siemens Washing M/C Heating Problem?

    Glad i could help 🙂

    October 11, 2011 at 8:38 pm in reply to: bosch exxcell d/w no heat #361053
    PINKY
    Participant

    Re: bosch exxcell d/w no heat

    Heat pump comes as one part { heater and wash motor } New part has changed so theres some wiring mods. 10/10 it will be open circuit heater. module fault is uncommon.

    Cut off the cir-clip. Pull out the motor. Can be done by taking off sides and front kick plate. first time will be about an hour. 20/30 about average

    Pinky

    October 8, 2011 at 2:30 pm in reply to: Bosch Dishwasher SMS50E06UK/01 E14 Fault Code #360877
    PINKY
    Participant

    Re: Bosch Dishwasher SMS50E06UK/01 E14 Fault Code

    ‘e14’ is a flow meter fault.. It the reed switch on the side chamber [left side] monitors water intake. From memory its called a contact on the parts info and is available as a separate part from the side chamber. hth

    Pink……..

    October 6, 2011 at 5:04 pm in reply to: bosch d/w sgs45e08gb/45 #360740
    PINKY
    Participant

    Re: bosch d/w sgs45e08gb/45

    Mains filter will not stop it coming on. Blowing fuse yes.

    October 5, 2011 at 5:01 pm in reply to: Bosch Dishwasher Recall #359875
    PINKY
    Participant

    Re: Bosch Dishwasher Recall

    That’s right. Bsh only changing semi intergrated and hard wired :rolls:

    October 3, 2011 at 7:13 pm in reply to: Siemens Washing M/C Heating Problem? #360325
    PINKY
    Participant

    Re: Siemens Washing M/C Heating Problem?

    No it just clips in, should be an analogue switch

    October 3, 2011 at 9:29 am in reply to: Bosch W.Dryer no heat on wash #360334
    PINKY
    Participant

    Re: Bosch W.Dryer no heat on wash

    No heat is usually caused by one of the stats on top of the heater box going o/c. But this is a Chinese appliance and they give really weird faults.

    The small pcb piggy backed onto the main board has the relays for the dryer on them and they do play up. Position 0110 on expolded diagram

    October 3, 2011 at 9:23 am in reply to: Bosch W.Dryer no heat on wash #360333
    PINKY
    Participant

    Re: Bosch W.Dryer no heat on wash

    No tap symbol doesnt indicate any heating promblems

  • Author
    Posts
Viewing 15 posts - 1 through 15 (of 260 total)
1 2 3 … 16 17 18