Forum Replies Created
-
Posts
-
Re: servis m0330s
you will probably see the circ fan pulsing as well,the pcb is faulty.
cheers chris
Re: lg gr-l206cvqa
Cheers for reply do you mean the circ fan in the freezer or is there one in the fridge?
cheers chris
Re: CPCA240FFK
depends on the symptons if you tell the cust to turn the machione to the off position and it still runs its the board,generally there are the lights flashing on the front i find it best to change the module first and advise re if the sensor has failed that will be extra for the part.I have only changed 2 sensors and tonnes of boards.
cheers chris
Re: Fridge and freezer stats
i have had so many issues with stats that i only fit gen ones now other than on the obvious old hotpoints etc which vt9s are fine for.i have found it eliminates call backs then you have to possibly charge a bit more for the gen which cust isnt over happy aboput.
cheers chris
Re: Performing Rights Society
I get loads of phone calls re this and letters i just ignore them it is ridiculous I have a small radio in the shop for the staff which they say i have to pay them for they can whistle as far as i am concerned.
Re: Small repairs
i find anything but a dyson and it gets scrapped unless it is blocked.I do advertise in yellow pages and put a line re dysons and find i get a lot dropped off i dont go out to them.
Re: I’ve been cloned:(
on a similair theme got a phone call last year on a friday night just got in from the vets the missus answered police on the other end wanting to speak to me,great what now they asked where i had been in the last hour as i had “stolen” £60 worth of diesel about 30 miles away.After they had checked i had been at the vets and not nicking fuel they asked when i had last been to essex as I had pinched fuel there,Turns out my van had been cloned and a transit was running about with my reg on.
Quite scary really so now i get a pull now and again and have a ref number i have to give them to prove who I am.cheers chris
Re: Masterfix
done 1 repair for them a month ago paid and replaced part used straight away no problems.
cheers chris
Re: Samsung j1453s
normally when these count down then back up they are trying to distribute uneven load,but i am sure there where some issues with the sensitivity of the board and there was a new board with a bigger tolerance for uneven loads.
Re: smeg wd16ba
spoke to smeg with this part number as cust wants it done asap and they have no record of part number they are saying there is a front board which need a shaft extension mod kit fitting and a rear spin board there is also a front dryer board which is obsolete.the part number they have quoted us is 811650224.
any ideas chris
