robbo1973

Forum Replies Created

Viewing 14 posts - 631 through 644 (of 644 total)
  • Author
    Posts
  • in reply to: hoover se 230 #182959
    robbo1973
    Participant

    Re: hoover se 230

    sorry dave for delay but i never use this addresss: robinsonrobbo@madasafish.com

    can you send info thanx chris. 😀

    in reply to: hotpoint fdw60g #183077
    robbo1973
    Participant

    Re: hotpoint fdw60g

    thanx for the help. the pump unit comes apart pretty easy 2 screws on the side and 13mm nut on impellor and slotted driver other end. the big nut is not part of the lower spray arm you push the sump up from the underside and this locking nut thing from the inside.calling it a nut might be a bit misleading as it is circular with four locating slots, a bit hard to describe but a bit similair to the way the newer zan square askolls fit approx quarter of a turn. the only reason i was asking is the cust says she had not tampered with it so i was not sure how it came loose 👿 .

    in reply to: hotpoint d/w fdw60 #181778
    robbo1973
    Participant

    Re: hotpoint d/w fdw60

    the neons flashing are 3 and 4 which relates too hardware failure not 1 and 2.pump running and emptying fine.

    in reply to: elba type px906 #181776
    robbo1973
    Participant

    Re: elba type px906

    thanx very much lads 😆

    in reply to: Candy frost free help please #178237
    robbo1973
    Participant

    Re: Candy frost free help please

    hi had this fault a lot i move the defrost sensor from inside the evap and tie wrap it too the evap entry after the capillary where it is the fattest never been back to one 😉 .the sensor is generally right next to the heater bringing off defrost too early.

    in reply to: SAMSUNG RS21DCSV1/XEU recurring fault or not fixed? #158984
    robbo1973
    Participant

    Re: SAMSUNG RS21DCSV1/XEU recurring fault or not fixed?

    hi all i have worked on tonnes of these and the problem is only cured by replacing the fridge evap cover. the insulation soaks up water and then starts icing up jamming fan etc samsung also recomend changing defrost term sensor (yellow wires) at the same time but there is definetley a modified back panel available hope this helps. 😆

    in reply to: Servis M7554 Running Constantly #176870
    robbo1973
    Participant

    Re: Servis M7554 Running Constantly

    hi flarkey is the ice in the fridge mainly concentrated on the higher part of the back panel or the corner or is it pretty even all over the back panel?.

    in reply to: Delonghi DFS 901 SS #177041
    robbo1973
    Participant

    Re: Delonghi DFS 901 SS

    i changed just the switch before conversion was available and switch burnt out within 8 months.Went back and done conversion a bit shocked when it came but was a piece of you know what 😀 good job as people dont like changing large items like range cookers. 😉

    robbo1973
    Participant

    Re: Samsung Fridge-Freezer RS21FGRS – Noisy fridge fan &

    hi the problem sounds like one i have come across in the past samsung have had a slight problem with some of the fridge evap covers soaking up water it sounds like yours has this fault. you need to change the fridge evap cover and defrost sensor.you will probably need aa engineer though. hope this helps.

    in reply to: hotpoint wd440 #174658
    robbo1973
    Participant

    Re: hotpoint wd440

    nice one got them should help in the future 😀

    in reply to: hotpoint wd440 #174656
    robbo1973
    Participant

    Re: hotpoint wd440

    thanx very much it would be helpful and it was dodgy contact on module cheers chris. 😆

    in reply to: hotpoint wd440 #174654
    robbo1973
    Participant

    Re: hotpoint wd440

    thanks very much going out tomorrow should be straight forward 😆 .are these fault codes available on this site i have checked known fault codes but none listed for newer machines.

    in reply to: candy ce10 washer dryer #156401
    robbo1973
    Participant

    Re: candy ce10 washer dryer

    numbers are 31116007 9927 4261 thanx.

    in reply to: hoover 6 #130555
    robbo1973
    Participant

    Re: hoover 6

    ta very much just started using site. 😀

Viewing 14 posts - 631 through 644 (of 644 total)