[scots]

Hi Jem

Meant to let you know, it wasn’t the dryer heaters, worth a go tho.
Suspect the board faulty so customer replaceing.

Thanks
Brian

[scots]

Good call Jem, I had forgotten about that.
Although haven’t seen it doing this before with a low test?

Thanks

[scots]

Cheers Dave, all fixed now

[scots]

Brilliant Dave,, It was actually the yellow that had the earth, which makes sense, the NTC.
Thanks

[scots]

Thanks for the help, The product code is 31100875.
The reading across them was in Kohms so I don’t think they are door lock.
I suspect its an NTC but not sure if they have 2 NTC’s? as there is one on the front, but that has red wires.
Thanks again
Brian

[scots]

I think you are right, does sound like the machine hasn’t registered the water in (reed switch) and overfills. P/switch switches on overfill.

[scots]

We use Maddocks, Connect and Qualtex. Did try ASWO as others on here rate it but almost everything I compared, was much more expensive
Might have to have another look thanks
Did get an email back saying the pressure switch would be dispatched within 24 hours, so here’s hoping

[scots]

Yes I also had a look on Google maps, I have sent money to them so fingers crossed. Its a Meile pressure switch and they are so expensive new.
Thanks for reply

[scots]

The part that was supplied was in the genuine elux labled packet, part number 3570700017 which is the part number from the Electrlux site.
I have written to Connect but as yet no reply.

[scots]

I accept that theses suppliers have a chance to also supply to the general public, but as in my example, its the price diference which annoyed me. Are we subsidising them supplying parts to the public?
Still awaitting their response.

[scots]

Hi Dave

Just reading it now, interesting, is this not how the Bosch DW monitor the draining too?

Thanks for this info again
Brian

[scots]

The LG ones are a real pain to do I agree but I have always manged so far taking the front panel off.. The Hoover Candy ones I gave up on and replaced with the wire one with the tightening screw.

[scots]

Thanks Ray,

Brian

[scots]

Thanks again Dave for the info.. Suspect the board tho..
Hi Ray heater tested ok.. I tested it from the plug on the top. thanks for help

I did run it on a timed program so I can only assume the dryer NTC ok?

Brian

[scots]

Sorted.
New relay fitted and track repaired, have ran it 4 times and all now ok. Not sure yet as to why the relay welded closed and track blown, its the supply to the inlet valve via a pressure switch?
But seems ok anyway.

Thanks to all who replied
Brian

[Author]

Posts