Forum Replies Created
-
Posts
-
Re: CDA Hob regulator CD56SS
Rang CDA, no parts available, part number they gave me was PV00695 similar to Nardi stuff, if anyone has any knocking about cheers.
Re: CDA CD251SS hinges
031199009932R is the part number, CDA say parts NLA, anyone got any knocking around, may be similar to Nardi stuff?
Re: Beko DFN05R10B Not Filling
Drain pump should run first, if its not running there could be a pump issue, either open circuit coil or supply to pump fault, it runs pump for about 30 secs, then fills with 4 litres, once 4 litres are detected to have passed through water counter (in 90 secs) it will initiate circulation pump. If it doesn’t detect water coming in ( or slow to fill because of poor flow rate) it won’t start washing.
Re: Beko DW601 Not Filling
Likely the wires from water counter are broken in loom at bottom of door, they are the fine wires.
Re: Stoves induction cooker no heat
Mostly the Induction boards have cooked because of the design of where the fan initiation switches are located, i’ve done quite a few of these, all under warranty, but imagine the cost would be too expensive for a chargeable call to pay for.
Re: Belling 100DF 444445412 thermostat
Sometimes the thermostat pops off the locating prongs at rear of selector switch causing this.
Re: Beko DSC 64W keeps cutting out
It shuts off automatically if water tank is full so to be honest it should make no difference, as it stop & can’t be used until emptied.
Re: Beko DCU 6130
Any clothes in it?
It looks to sense the dampness of items in there, if no clothes or small load in it maybe not contacting sensor bars, therefore sensor drying function shuts off too early. Try it on timed drying..
Water level full detected will also shut it off after short time.Re: Beko DCU 7230W Burned PCB
Most Engineers won’t go to component level, i’m an Engineer who does about a dozen of these per week, never ever have I gone down to component level on a p.c.b, Beko Engineers don’t go down to component level.
Would recommend you order a p.c.b.Re: oven cuts out after it its been on for a while
Few things needed info’ wise, is it a static or fan oven, when you say “cut’s out” does it all stop or fail to heat, light go out , fan stop ??
APL 1304 is showing as a hob ?Re: AEG L75670WD
As to who to call, i’d advise an engineer perhaps :lesson:
e10 means the appliance hasn’t detected water level reaching required level
Re: Beko DRCS76S Stopped working – seemingly now dead
No internal fuse i’m afraid, new p.c.b i’d imagine
Re: AEG Lavermat L14840 – E10 on drying
Suspect the water inlet valve for drying has gone open circuit, they are mains voltage supplied.
