Forum Replies Created
-
Posts
-
Re: Connect what a joke!
Perhaps we should start a chart of trade suppliers who state next door delivery but dont – name & shame!
I’m awaiting a delivery from Homespares promised last week – still no show!!!As succinctly put as the customer (awaiting the repair) put to me “Bl##DING WHEN THEN”
Brian.Re: Prima Dishwasher
If Whirlpool check the NTC – little finger like probe in the centre of the base 😉
If that’s ok count the beeps and check the number against the “known error codes” link above. Another common fault on w/p’ d/w is the black grid like component to the right of the base with three connections. unscrew it clean it and retry – do not penetrate the membrane!
Brian.Re: Indesit Move To Turkey?
Next stop Hades – in keeping with the product and yet an even cheaper labour force 😈
Brian.
Re: bosch dishwasher sgs43e02gb/35
I agree with all that’s been said above – But for future reference you can get to check the drain pump from the front of the machine. It’s positioned on the left hand side of the base – just remove the screw holding the cover over the pump and you can see the impellor & then check for any blockages. 😉
Brian.
Re: Zanussi DC512W table top Dishwasher not heating
Is that the correct model number cos I cant find it on TDS off line?
What’s the PNC number?
If it has an EDW1001 PCB fitted check for the usual – dry joint on board at the heater connector. 💡
Brian.
Re: Bosch motor removal
You are right Gegsy it’s down to what works for you. I would now always place a machine on it’s back than on its side – in my opinion less chance of suspension dampers and legs coming a drift, as has happened in the past on their side.
Just my opinion! – this definately better for me 8)
Re: Bosch motor removal
superfix wrote:
senseib wrote:
Why remove the motor? I’ve changed dozens of Bosch carbon brushes by placing the machine on it’s back and gaining access from underneath 8)Brian.
Why ❓
Times money and if its quicker with no come backs – why not 😉
Re: Bosch motor removal
Why remove the motor? I’ve changed dozens of Bosch carbon brushes by placing the machine on it’s back and gaining access from underneath 8)
Brian.
Re: Hygena auto drum pulley
Thanks for the response Chris, but according to my system – 26800670 is out of stock at m’parts.
Does it say in stock on your’s?
Brian.Re: Hoover A3790 Indicator Drum
Is this this the right part number #09035882 the one with letters on ❓ If so it’s still available at masterpart 😕
HTH,
Brian.Re: Fitting a new support tube on Hotpoint twin tub
I think I will pass on the Thompson Twintub – when they go wrong just cut out the repair side and skip to contacting the council to come and dump it 😡 Cant see any of those being around in 30-40years :rolls: Unlike their machine gun eh! 😆
Brian.
