Forum Replies Created
-
Posts
-
Re: Hotpoint Washer Dryer WD63 Eating TOC Kits
Turning the dryer off before it’s finished the cooling cycle can cause the one shot toc to go.
Brian.
Re: Fitting a new support tube on Hotpoint twin tub
I know this much – there will never be a Merloni Heaven – that lot are going straight to HELL!!! 😈
Brian.
Re: Fitting a new support tube on Hotpoint twin tub
Martin wrote:
senseib wrote:
Shame on you Martin 😆So I get the blame for the demise of the twintub now do I? :rolls:
There’ll be no room in twintub heaven for you that’s for sure 😥
Brian.
Re: Fitting a new support tube on Hotpoint twin tub
Martin wrote:
allan wrote:
Does anyone make a decent twin tub?No! Twintubs are history……move on 😉 🙂
Try and tell that to the old age pensioner that only knows how to use a twin tub and would have to fork-out a fortune to convert their kitchen to accommodate an automatic – might just finish them off altogether!
Shame on you Martin 😆
Brian.
Re: Zanussi ZWF 1427
Are there any neon lights lit or digital display? The edge connector on the front pcb can give trouble on this machine, try disconnecting, squeezing the connections together and then re-connecting – might just cure it 😯
H.T.H,
BrianRe: Fitting a new support tube on Hotpoint twin tub
You have to take the outer cabinet off and the wash tub out to easily access the three bolts that hold the plastic support tube on. If memory serves me right, the hardest part is getting the old tripod off – good luck 🙁
Stock up with WD40 & penetrating oil – you’ll need it 😆H.T.H,
Brian.Re: Zanussi DCE5655
This m/c has a EDW1001 module fitted – a common fault is a dry joint at the heater connector on the board!
HTH,
Brian.Re: DRIVE BELT WANTED ASAP
Masterpart – part no: sil36060900 £7.99 + vat p/p belt EL 1197J5
Or POL78 belt 1196J5Mael at Qualtex – £4.11 + vat & p/p 😉
Brian.Re: HAP0010
Lower oven element 1400w 524012200. Base element 1800w 524012300. Grill element 524013300
Brian.
Re: Aeg Enr 911234124 D/W
Pretty sure that model has the motor driven disc that directs the flow from the top arm to the bottom arm on rotation. More than likely drive field coil open circuit and the disc is stuck in the upper arm flow position.
Expensive because I think its all part of the circulating motor and therefore sold as one complete unit (not certain though)? However, in the passed i have managed to turn the disc so it is open between both – allowing flow to upper arm and lower at the same time! Powerful motor so even though apertures only half open should drive both arms round. Worked in the past for me 😀
Hope this helps,
Brian.Re: Bauknecht gsi3330s over filling
Split in pressure stat hose? If not then faulty pressure stat perhaps! (assuming pressure switch fitted).
Brian.
Re: Bosch WFL2260GB/01
Drain hose below syphoning level? – partially blocked inlet valve? Kinked inlet hose, are the first things that come to mind!
Brian.
