Forum Replies Created
-
Posts
-
Re: Zanussi IZ 141 S
is there a code number on the display ? if not it is possibly the door interlock , engineer required for this im afraid as it could be a control board prob also
Re: hotpoint WF321 no leds on fascia board
sorted it with a s/h facia board from a h/point wt machine , must have taken out the fascia when the main board blew ! cheers martin
Re: hotpoint WF321 no leds on fascia board
i just got it from emw martin , are you sayin its a faulty board from them ?
Re: whirlpool 3RLEQ8033SW1 wont restart
there is no capacitor , it has a heavy duty relay mounted on the motor , so i suspect it could be dodgy , its not available to buy seperately so i would say that sorts that
Re: neff S5444X1GB/22 wont finish cycle
yeah the fill issue is sorted , i see some tips on here about a relay on the board need a solder repair cheers
Re: indesit WD12x uk wont go to dry program
i cant count em martin they are constant , 2 flashes per second for ever,it never stops , i’ll send board to them anyways cheers
Re: neff S5444X1GB/22 wont finish cycle
replaced the jug impeller as it was taking for ever to fill, now wont heat water no power going to the element , board fault i suspect !!
Re: bosch control boards replacement
ah yes it makes more sense now that im at the machine , different program setting according to the options of the machine cheers A1
Re: samsung rs21dcns, fridge side freezing evap ,
ok yeah its located r/h side of evap cable tied to the evap coils
Re: samsung rs21dcns, fridge side freezing evap ,
nah defo not blocked , and not this time after i left either , i poured water down until i heard it in the catch tank
Re: samsung rs21dcns, fridge side freezing evap ,
yeah Bryan i checked them both seperately and meggered em too , and changed the sensor also , i didnt have a drain heater to replace it but i was sure it was fine
Re: samsung rsh21dcns, fridge side freezing evap ,
sorry guys , its an rs21dcns , the heater is fine , i meggered everything no problems when i opened the evap cover the coils were clear of ice but there was a block below the coils on top of the gutter heater and it was clear ice and the sides of the evap and top were white ice , i can only suspect no power coming to the gutter heater ,the thermal fuse has connectors , i dont think it can be put the wrong way around ?
