Forum Replies Created
-
Posts
-
Re: neff S5444X1GB/22 wont finish cycle
yeah he said there were half panels on each side one torx front and back and it was off , dry base , i dunno what else it could be only that it takes too much water , and the level inside the tub is too high ? . if it did would the switch inside activate ? he sayes it looks like a mushroom , but when the level goes back down would the switch not reset to normal position and stop pumping out? i dunno i guess i’ll just drive up there
Re: neff S5444X1GB/22 wont finish cycle
yeah thats what i meant Martin , i got him to take off side panel base clear of water
Re: neff S5444X1GB/22 wont finish cycle
had a chat with the customer , he sayes no water in base and he ran it empty so nothing stuck in float safety switch , too much water coming in ? activating the float inside ?
Re: neff S5444X1GB/22 wont finish cycle
cheers Martin , i dont have a heater box so fingers crossed it aint that
Re: Hotpoint FFA74G Fridge Freezing,Freezer warm
did you check the diverter valve? pm me your email add
Re: work dead
hi all , just to let you guys know whats goin on over here in de emerald isle , this has been the quitest week in about 4 years for me , last week was much busier , then again everyone is back from hols , money spent , pockets empty , i expect it to pick up big time next week , in general its busy 4 to 5 calls every day , mind you everyone is asking now how much is the call out?,…. ok can i get back to you ! i have found that the domestic calls are dwindleing , most of my work comes from independent retailers giving my name and property management companies , long live the students may they break every appliance they encounter hurrah !!!
Re: hotpoint FDW60 dishes wet after cycle finishes
checked it out replaced flowmeter , no change removed wash motor , pump ,fill matrix , hoses etc flused out system ,checked wiring and connections all fine no hard wire or burnt connections , back together again , no change , machine is 7 yrs old so cust going to buy new one thanks all
Re: beko dcrs 68 stopping
cheers fella ,i just dont understand how it tumbles both ways in test mode ? is it not using the same relay , caps ,doides etc in normal op ? is it because its isolating the operations seperate parts of the program ? yeah i might try emw depending on the price of a new board thanks
Re: beko dcrs 68 stopping
originally when i removed the back cover half of it came on then later all of it was on , all i can say for definite is that it was not very hot in there when i was going through the test program
Re: bosch WTS 84516gb/08 wont start
MAG wrote:I’ve had a few of these in the past and it was the plug falling out from the switch.
hi Martin
he said the plug fell out of the switch ! hardly the wall outlet he’s on about , i take it its the door switch which also has a plug connector going into it , and i believe mag is his user name ?
