Forum Replies Created
-
Posts
-
Re: servis 4605s not heating
this is the thermo resistor on meter range of 20k ohms it reads 792 , 
this other one is the stat reading 0.5 0n 200 ohms range this is stamped with nc on the bodyRe: servis 4605s not heating
actually the reading on the meter is constantly moving up and down is that right ??
Re: servis 4605s not heating
no joy keith its a nc stat showing continuity so thats that thanks for the tip
had a look at the pcb’s today all look fine , i cant get it into diagnostic mode the sccreen has the key symbol on it when i was checking the wiring at the main pcb i put the power on and left the 12 pin connector off and then connected it with the power on and the screen came alive , but the compressor wouldnt work , so i plugged it out again and powered up after a couple of mins and it was back to the frozen screen help
cheers nomad , its not the antiflood i’m afraid , i m able to operate it by hand with the side panel off ,and then it shuts the solenoid off and pumps the water out but as soon as i put the antiflood back to its normal position the solenoid is off again shutting and opening in rapid sucession ?
Re: whirlpool adp 4601 not heating
havent seen it b4 myself ? , l took it off and put a live feed to it , nothing doing its goosed thanks for your help mate
Re: aeg oko-lavamat 86720 update C9 error
no didnt test , do you know any values for the resistance tests cheers
Re: whirlpool adp 4601 not heating
yeah , i can see the loom coming up from the components under neath , looks fine though no chaffing ar trapped wires , i would replace the heater element but its 140 quid cant believe it just a bit o plastic housing with the flat element on one end ????
p
