Forum Replies Created
-
Posts
-
Re: SAMSUNG WF90F5E3U4W/EU MOTOR STAMMER
100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} main pcb, unless the bearings have gone. make sure you get serial number and order from GSPN as you could get the wrong one from connect if ordering by model number. there are 3 revisions for this model.
Re: Daewoo american fridge freezer not freezing ice
has the customer loaded it too the hilt blocking all the vent holes, its a common problem on some air blown side by sides, i normally tell customer to leave at least an inch gap under shelves. 2.5cm in new money. 🙂
Re: Hoover GIAS
dont forget the 2 tubs a day to fit, a mountain of parts sitting on your drive when you get home, and sorting your route running order times for the next day and emailing that off before 12pm, been there done that NEVER AGAIN !.
Re: Samsung RSG5UCRS1/XEU – flap problem
plastic pin that holds the return spring has broken off, it will need ice chute assy, common on these.
Re: Beko washing machine heater fault
had one on a hoover machine the same as this and it turned out to be the heater retainer in the tub had broken causing the heater to rub against it and rub through the thin tin of the element.
Re: Beko Tumble Dryer DSC64W Not getting hot
there is also an ntc on heater which are common to fail, which causes no heat. there is a test cycle for these which tells you what has failed.
Re: Hoover VH W6540-80 Washer/Dryer TD overheat stats tripp
check to make sure fan motor isn’t loose in its housing, they are prone to coming loose , causing fan to stop and take out stats.
Re: wae2436gb02
it is 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} the child lock that has been set.
Re: DIPLOMAT ADP8532
sorry about hijacking this post, but I went out to one of these today, cannot select p and salt light on, there was no water in base, just wondering if the circulation pump can cause this ?
cheers.Re: lg dishwasher d1453w showing nE
cheers for the reply,I did think that it was HE at 1st, but it is definitely only showing bottom left and right and middle segments of the 1st number. and all the segments are lighting up, iv ordered a pcb anyway and see how it goes, cheers.
