[smartin]

Re: Samsung heat pump tumble

In what respect does it not dry properly ?, because there are so many variables involved in these.

[smartin]

Re: Samsung heat pump tumble

is it used in a small cupboard ?, condensor clear ? does it give a HE error ?

[smartin]

Re: beko dryer

I had the same issue with my own dryer, it turned out to be the board.

Martin

[smartin]

Re: Rangemaster Falcon 8186 011128

wrong type of pan being used or board failure.

[smartin]

Re: Bosch Dishwasher Heat Pump failed prematurely ‘again’

Also if they are using these all singing and dancing tablets… it could be oversudsing, heaters dont like heating foam very much.

[smartin]

Re: Beko/DAG

We dropped D&G a few months ago because of their rates, which made it unprofitable. As you probably know a lot of the appliances they take on (if you take Beko out of the equation) are extremely difficult to get parts for.

[smartin]

Re: Bosch Heat pump Dryer WTW84560GB/11

The other important thing is that it takes about 15 mins before any heat can be felt inside.

Martin

[smartin]

Re: Samsung American

I have added part number for water tank if it has split, and a fuse board if the fuse has blown in pcb box.

DA97-00670F water tank
da82-01238e fuse board

Martin

[smartin]

Re: Fisher & Paykel DD60DCHX7 P/N 89383-A S/N MHP739039

E2 and U6 equate to the motor not turning, the fact that it takes the trip aswell i would say that water is leaking onto the hall sensor (really small pcb that sits in motor windings) and is shorting out, but of course it could be something else.

[smartin]

Re: Electrolux EWX14450W

if you have not already i would check pressure hose for holes, i have had a couple of these where it has rubbed through on the tub.

[smartin]

Re: smeg washer dryer

i agree with eastlmark, check fan blades, i have been out to a few which were multiple visits, even though you could feel a good airflow, but the blades had a fair amount of fluff build up on them.

[smartin]

Re: hinge?

front panel is probably bent, large screwdriver in hinge receivers, push towards oven, job done .

[smartin]

Re: Siemens DW door issues

when door is open and in the down position, make sure there door isnt bent below the 45 degrees angle

[smartin]

Re: SAMSUNG dropping service partners ?

I had a feeling it might be a big national company, but i thought it might have been the other one to be honest, cheers

Martin

[smartin]

Re: SAMSUNG dropping service partners ?

Thanks Ken that`s basically what i have heard, i would be interested to know who these super agents are though.

[Author]

Posts