[snig]

Re: Hotpoint FFB6187 icing up

Door shuts fine and they never admit to leaving it open!

[snig]

Re: Pulling machines out on board

I now use 3mm ply as its much harder wearing than the hardboard i used to use. I have even varnished it in an attempt to stop the edges from splintering. Cost £3.50 from local hardware store and lasts for years.

[snig]

Re: Indesit dif16 dishwasher thermistor?

Found fault was actually caused by a slug crawling across pcb and frying them both. As pcb needs to be programmed its a write off !!

[snig]

Re: Indesit dif16 dishwasher thermistor?

Thanks for reply. Obviously need to go back for another look. Moral there is never be in too much of a hurry

[snig]

Re: Hotpoint fridge RLA84G freezing

Sorry yes i mean evaporator and yes it is foamed in.

[snig]

Re: bosch fridge pcb modify

Sorry, to clarify above, IF module has 4 pin thermistor connection short 1&3. If it has 3 pin coonector its 1&2, leave 1&3 connected to board

[snig]

Re: bosch fridge pcb modify

Hi, the kit should come with instructions but from memory all your doing is shorting the fridge thermistor.Found a note i made from last one i did, 4 pin connector, short 1 & 3. 3 pin connector short 1 & 2, leave 1 & 3 in place ( hopefully makes more sense when your looking at it )

[snig]

Re: Hotpoint fridge RLA84G freezing

Hi Crockett, i believe this range has had some trouble with the phial tube coming away from the condenser ! If this is the case then there is not much you can do with it.

[snig]

Re: Indesit washer dryer element fault !

Called back today with another element. On testing i found there was no water to condenser and i was getting only 60 volts at the valve ! Cant see that this would cause element to fail but is it indicating a pcb fault?

[snig]

Re: h/pt dwf30

Is it heating at all ? check relay joint on pcb common problem

[snig]

Re: Kenwood Dishwasher

Just done one of these last week. Module fault on mine, module was about £70. EMW may repair heating faults for less !

[snig]

Re: Whirlpool AWO/D 4306

Also interested to know how to read these fault codes. How do you get to F23?

[snig]

Re: Indesit IWDC6125 Runs dryer after wash cycle

check for earth faults on these but also check water valve solenoid coils for shorting!!

[snig]

Re: Whirlpool AWO/D wash & rinse light fault code

Still hopeing someone can help with some info on this ?
Doesn’t seem to be in fault code book or listings on this site!!!

[snig]

Re: bosch dishwasher sgs53c02gb/08 floating magnet.

Don’t know about Bosch part No. but it is 5031687711250 on connections. (both parts )

[Author]

Posts