[snig]

Re: Whirlpool AWO/D 6528 Dead

Yes, i have mains voltage at the blue connector but no lights, i suspect from further reading it is an unprogrammed board from connect , or are you saying even if unprogrammed it should light up ? The fact several people before me have had the same problem with a new board makes me think they can’t all be faulty and there must be a reason ( ie, unprogrammed board ? )
If this is the case, why are they selling unprogrammed boards which are no use to 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of us, and why are the programmed boards so much more expensive ?

[snig]

Re: Neff dishwasher stopping mid prog.

Yes, pumps out fine, but fault seems intermittant ?

[snig]

Re: BSH Dishwasher Service Manual

just pm ed you Many thanks

[snig]

Re: Beko WMB 81445 stuck on reset / 15 mins

Thanks for that. 1st one i’ve come across !

[snig]

Re: LG WM16341FD won’t spin

No anti flood float but i see your thinking, i did check pressure switch originally with no joy.

[snig]

Re: LG F1443KD6 11kg won’t spin

Thanks for that,new module listed at £116 retail so quite expensive !Probably worthwhile, IF it cures the problem.I have just replaced the rear shock and it does seem better so have left for customer to try that first.

[snig]

Re: LG F1403YD no display

No i didn’t. cost started to spiral and customer rightly pulled the plug

[snig]

Re: Siemens SN26M653GB/44 dishwasher won’t start

Yeah my thoughts too. Looked with magnifying glass and tested door switch with another magnet but all appears ok !

[snig]

Re: Whirlpool awm9000 pcb configuration

I was afraid of that. Hopefully they will swop it as it was not listed as non configured.

[snig]

Re: How to configure Whirlpool awod ?

Yeah, i was afraid of that. Another write off then!!!

[snig]

Re: Whirlpool oven configuration codes

Thanks john, i’ll go back today and try that. Out of interest should that be on the rating plate normally,as suggested on the info sheet or am i reading it wrong?

[snig]

Re: Britannia Range Cooker model SI9TF

Don’t wish to throw a spanner in the works but i was under the impression if it was a gas appliance then you need a gas certificate. I may be wrong ? Would be interested to know as have been turning away simple electrical faults on dual fuel appliances.

[snig]

Re: whirlpool american washing machine fills at end of spin

Thanks for replies. Yes it seems to do several short bursts during spin but one right at the end which then leaves clothes wet. Can this be normal ? I will check in fascia for sequence chart thanks

[snig]

Re: Indesit IDP148UK dishwasher module, preprogrammed or not

Thought so, another write off then !!!

[snig]

Re: Hotpoint FFB6187 icing up

don’t know but certainly he’s checking it too often, maybe over obsessing ?

[Author]

Posts