Forum Replies Created
-
Posts
-
Nothing obvious on the board, and no fault codes, just intermittantly goes back to default temperature without interupting cooking.
Yeah, its just the rear one thats noisey so at least not difficult to change, was just trying to avoid taking it out twice.
I would assume they mostly have the same size bearings so anyone with a bosch motor kicking about who could have a look would be most appreciated
Re: LG F1443KD starting up on its own
Unfortunatly didn’t have another one to compare. To be clear, socket tests ok,but when testing output side of pcb i’m getting 50v on earth terminal.
Re: LG F1443KD starting up on its own
yes, did earth loop test which was fine.Think i have an old LG in the workshop, hopefully test that one for comparison.
Re: zanussi lindo 300 dead
I see. think there are 4 or 5 red wires to front board, i suspect if i take the front board out i should be able to figure out testing for voltages, unless anyone has a wiring diagram.
By the way it was the main board i changed. There is also a third board on this one but that seems to just be for motor ( 3 phase i think )Re: Hotpoint TDW SF 83b EP (UK)
Hi, sorry to jump in on the end of this but any chance you could pm me the manual as well, been struggleing to reset one since f04 fault !
Re: samsung washer dryer wd80 dc code
In that case its probabley door interlock i guess ?
So much for my googleing skills !!, am i correct that on some models the dC code relates to out of balance ?Re: Smeg DF612 SDX dishwasher unlisted fault code ?
Not sure it runs for that long ,but i would have to check that !
