Forum Replies Created
-
Posts
-
Re: Diplomat/Servis APM8703/02 W/D Keeps Filling – Tried…
i would think its got to be the pressure switch or a blockage in the pressure switch tube or a hole in the pressure switch tube.
Re: Late hotpoint motor plugs
they cause the machine not to start, by not allowing the door lock to work.
Re: Why does a comm stick cost £6?
leavemetogetonwithit wrote:I do have a soft one which I’ve had for 25 years but my hard one is all broken 😯 .
Mike.i am sorry to hear that there are pills available now for that sort of thing. 😀
personally i have never had one myself.Re: Hoover OPH614 drain hose?
its the same drain hose hoover have been using for years for the pump at the front of the machine in fact it fits every hoover machine with a front filter.
Re: washine machine filling when off
thanks very much that looks like the thing i am looking for
i will give it a try.Re: Creda 37373 Dryer
johnnyj wrote:
suedehead1 wrote:
how fast is way too fast the small dryers do turn quicker than the big dryers, i assume you have wired it up correctly,
the motor pulley size wont make a great deal of difference
to the speed of the drum.
the size of the capacitor wont make any difference to the motor
speed.After being in this game for about 30 years, i am well aware the capacitor is a start capacitor and wont alter the speed i was only advising that the newer motors require a differant capacitor which can cause the motor to stall, i wouldnt think wiring incorectlty would’nt make much differance as the heat is not taken off the heater on reverse tumble unlike the the condensor dryers.
sorry not trying to imply you were wrong about the capacitor i was just thinking out loud.
Re: Creda 37373 Dryer
how fast is way too fast the small dryers do turn quicker than the big dryers, i assume you have wired it up correctly,
the motor pulley size wont make a great deal of difference
to the speed of the drum.
the size of the capacitor wont make any difference to the motor
speed.Re: White Knight CL767 Tumble Dryer
i would say it was the thermostat next to the cut out one but i would normally change both.
Re: hotpoint wdd960 f13
there was no mesh on this one its quite a new machine,
ran it with the door open and got a good flow of air through it
but fan motor keeps cutting out and still showing F13.Re: hotpoint wdd960 f13
thanks didnt think about that its only just over a year old
and is not used much but i will give it a try.
thanks.Re: hotpoint wdd960 f13
thought i would use an old post,
i have got the same problem F13 changed the thermistor and checked the wiring thoroughly.
the dryer runs for 10 minutes then the fan motor and heater cut off
then F13 comes up.
spoke to tony at emw who said it wasnt a pcb fault,
any ideas welcome.
